Rear door trims
In this manual: Rear door trims
~2min read
- Assembly overview - rear door trim
- Removing and installing rear door trim
Assembly overview - rear door trim
Overview shown for left side of vehicle as an example
- Rear door trim
- ⇒ Rep. gr. 70 ; Removing and installing rear door trim
- Clip
- Qty. 6
- Bolt
- Qty. 2
- 4,5 N·m
- Rear window regulator button
- Left-hand drive vehicles: with rear driver side window regulator button - E711-
- Right-hand drive vehicles: with rear passenger side window regulator button - E713-
- ⇒ Electrical system; Rep. gr. 96 ; Controls; Removing and installing window regulator switches/operating units in doors
- Button trim panel
- ⇒ Rep. gr. 70 ; Removing and installing button/switch trim
- Rotary clip

Removing and installing button trim
Special tools and workshop equipment required
- wedge - T10383-
The rear driver side window regulator button - E711- and rear passenger side window regulator button - E713- will henceforth be referred to as "buttons".
Removal and installation are described for the left side of vehicle as an example.
Removing
- Unclip button trim -1- together with button -2- using wedge - T10383- -3-.

- Disconnect electrical connectors.
Installing
Install in reverse order of removal, observing the following:
- Renew any damaged securing elements.
Removing and installing rear door trim
Special tools and workshop equipment required
- Wedge - T10383-
Removal and installation are described for the left side of vehicle as an example.
Removing
- Remove button trim ⇒ Rep. gr. 70 ; Removing and installing button trim .
- Unscrew bolts -1-.

- Turn rotary clip -1- by 90º in direction of -arrow-, and release it.

- Release clips -2- of rear door trim -1- using wedge - T10383- .
- Pull rear door trim -1- upwards out of window slot inner seal.
- Disconnect electrical connector.

NOTICE
Risk of damage to the Bowden cable due to deformation.
- Do not bend or kink the Bowden cable.
- Detach Bowden cable -1-.

Installing
Install in reverse order of removal, observing the following:
- Renew any damaged securing elements.
NOTICE
Risk of damage to the locking mechanism.
- Always turn the locking mechanism from position -2- to position -1-.
- The door trim can only be installed when the locking mechanism is in position -1-.
- Insert clips into rear door trim.

Tightening torques
- ⇒ Rep. gr. 70 ; Assembly overview - rear door trim
Was this page helpful?