Explanation of symbols
In this manual: Explanation of symbols
~1min read
Sanding
NOTICE
Risk of corrosion when sanding through the cathodic dip primer.
- Do not sand through cathodic dip primer.
- Carefully sand the marked areas by hand.

Seam sealing
Sealing
- Apply sealant to marked areas.

Fine seam seals
- Fine seam seals in the marked areas require that the sealant extend at least 3 mm from the seam in each direction and must have a height of 2 mm.

Coarse seam seals
- Coarse seam seals in the marked areas require that the sealant extend at least 20 mm from the seam in each direction and must have a height of 2 mm.

Smoothing seals
- Following application, smooth sealant in the marked areas.

Important
- When smoothing the sealing seam, ensure that the sheet metal edges which are to be protected are not exposed. The metal must be covered with a sufficiently thick layer of PVC.
Brushing seals
- Following application, brush sealant in the marked areas to uniformly cover surface.

Important
- When brushing the sealing seam, ensure that the sheet metal edges which are to be protected are not exposed and that the metal is covered with a sufficiently thick layer of PVC.
Sealing the folded seam groove
- The marked areas must be closed following application of sealant to the "U" of the folded seam.

Important
- When brushing the sealing seam, ensure that the sheet metal edges which are to be protected are not exposed. The metal must be covered with a sufficiently thick layer of PVC so that the groove in the folded seam remains closed.
Cavity sealing
Sealing cavities
- Marked areas must be sealed following body repair.

Was this page helpful?