Parking brake
In this manual: Parking brake
2steps
~12min
1/5difficulty
Done 0 of 2
- Assembly overview - parking brake
- Removing and installing parking brake motor [V282]/[V283]
Assembly overview - parking brake
Overview is shown for left side of vehicle as an example
- Left parking brake motor - V282-/right parking brake motor -V283-
- ⇒ Rep. gr. 46; Removing and installing parking brake motor [V282]/ [V283]
- Bolt
- 8 N·m
- Bracket
- Brake carrier

Removing and installing control unit for electromechanical parking brake [J540]
Control unit for electromechanical parking brake -J540- is integrated in ABS control unit -J104-.
- Separating and connecting ABS control unit -J104- ⇒ Rep.
gr. 45; Separating and connecting control unit on hydraulic unit
Removing and installing parking brake motor [V282]/[V283]
Removing
Left parking brake motor -V282- and right parking brake motor -V283- are referred to hereafter as parking brake motor.
Removal and installation are described for the left side of vehicle as an example.
Important
- Switch off ignition for at least 30 seconds before disconnecting electrical connector.
- Disconnect electrical connector -2- on parking brake motor -1-.
![Volkswagen ID.4. Removing and installing parking brake motor [V282]/[V283]](/media/volkswagen-id-4/353/images/manuals/353/volkswagen_id_4_removing_and_installing_parking_brake_motor_v282__868.webp)
- Remove brake shoes, and unhook parking brake cable from brake shoe ⇒ Rep. gr. 46; Removing and installing brake shoes.
- Press down locking lug in bracket, and turn parking brake motor out of bracket.
Installing
Install in reverse order of removal, observing the following:
- Carry out function "Basic setting brake system" using ⇒ Vehicle diagnostic tester ⇒ Rep. gr. 00; Access to diagnoses.
Tightening torques
- ⇒ Rep. gr. 46; Assembly overview - rear brake, drum brake
- ⇒ Rep. gr. 46; Assembly overview - brake shoes
Was this page helpful?