Preparing rear lid drive unit VX69/rear lid drive unit 2 VX77 for disposal
In this manual: Preparing rear lid drive unit VX69/rear lid drive unit 2 VX77 for disposal
~1min read
CAUTION
Risk of eye injuries due to metal swarf.
Eye irritation and injury possible.
- Put on safety goggles.
Note
Type of joint/step at left and right drive unit -1- depends on equipment/version.
- Cut open outer protective sleeve -2- all around at a distance -a- from the joint/step using a commercially available angle grinder -arrow A-.
- Dimension a = 15 mm
- Remove protective sleeve -2- in direction of -arrow B-.

- Clamp motor side of drive unit -1- in a commercially available vice -2-.
CAUTION
Risk of eye injuries due to metal swarf.
Eye irritation and injury possible.
- Put on safety goggles.

- Cut open spring wire of compression spring -3- in longitudinal direction -4- using commercially available angle grinder until compression spring -3- is free of stress in longitudinal direction -4-.
Important
- If the compression spring -3- is not free of stress after the visible spring wire has been cut open, the compression spring -3- must be cut open further, including cutting into the remaining plastic tube.
Was this page helpful?