Preparing gas strut for disposal
In this manual: Preparing gas strut for disposal
~2min read
Important
- Only gas struts that have been depressurised may be disposed of.
CAUTION
Risk of injury caused by flying metal shavings.
Eyes and skin can suffer irritation or injuries.
- Put on safety goggles.
- Put on protective gloves.
- Saw or drill open gas strut -1- at notch -2-.
- Saw or drill open gas strut -1- at distance -a- measured from edge of housing -3-.
- Dimension -a- = 20 mm

Preparing covered gas strut for disposal
Covered gas strut is referred to hereafter simply as strut
CAUTION
Risk of eye injuries due to metal swarf.
Eye irritation and injury possible.
- Put on safety goggles.
Note
Type of joint/step at left and right strut -2- depends on equipment/ version.
Cut open outer protective sleeve all around at a distance of -dimension a- from the joint/step using a commercially available angle grinder -arrow A-.
- Dimension a = 15 mm
- Remove protective sleeve -2- in direction of -arrow B-.

- Place a cleaning cloth underneath to catch any escaping oil.
CAUTION
Risk of eye injuries due to metal swarf.
Eye irritation and injury possible.
- Put on safety goggles.

Cover area around hole with cleaning cloth.
- Cut open/drill gas strut cylinder -2- at a distance of -dimension b- -arrow-.
- Dimension b = 50 mm
Clamp cylinder side of strut -1- in a commercially available vice -2-.
CAUTION
Risk of eye injuries due to metal swarf.
Eye irritation and injury possible.
- Put on safety goggles.

- Cut open spring wire of compression spring -3- in longitudinal direction -4- using commercially available angle grinder until compression spring -3- is free of stress in longitudinal direction -4-.
Important
- If the compression spring -3- is not free of stress after the visible spring wire has been cut open, the compression spring -3- must be cut open further, including cutting into the remaining plastic tube.
Was this page helpful?