Self-adhesive components
In this manual: Self-adhesive components
~2min read
Specifications for self-adhesive components
Special tools and workshop equipment required
- adhesive strip remover - VAS 6349-
- hot air blower - V.A.G 1416-
- platform scale - VAS 231 007-
Temperature requirements for self-adhesive components
Important
- The temperature of the workplace, the vehicle and the components must be the same and must correspond to the processing temperature.
- The processing temperature is between 20 ºC and 35 ºC.
Removal of self-adhesive components
NOTICE
Risk of damage from high temperature.
- Protect adjacent components from heat exposure.
- Use hot air blower - V.A.G 1416- to heat up component to 40ºC prior to removal.
Removal of adhesive residue
Important
- Adhere to flash-off time of 3 minutes for the adhesive remover.
- Remove adhesive residue from paintwork using adhesive strip remover - VAS 6349- , cleaning cloth and adhesive remover ⇒ Electronic parts catalogue (ETKA) .
Cleaning bonding surfaces on body side for self-adhesive components
Important
- Before installing component in question, adhere to flash-off time of cleaning solution which is 10 minutes.
- Bonding surface must be dry.
- Clean bonding surfaces using cleaning solution and a new, lint-free cleaning cloth.
Specifications for installation of self-adhesive components
Important
- Do not remove protective film of adhesive tape until immediately before installation of component.
- Any application of paint on painted bonding surfaces must be complete and be at least "ready for installation" ⇒ General paint information .
If a manual pressing force is specified for a component:
- Test the manual pressing force using the platform scale - VAS 231 007- .
Note
Example for conversion: 70 N pressing force equals approx.
7 kg.
Continued
Decorative films and protective films
After installation
- Pull off application tape at an angle of 180º.
All vehicles (continued)
- Press on component/adhesive tape firmly over entire bonding surface.
- After installation, carefully check the components for secure fit.
- Observe the minimum drying time of 60 minutes at processing temperature.
- If present, observe deviating minimum drying time for the respective component in the relevant procedure.
- During the minimum drying time, the vehicle must be standing on a level surface at processing temperature.
- Mechanical work affecting the component to be bonded (static and dynamic loads) is not permitted during the minimum drying time.
Important
- To ensure that the vehicle is operationally safe, the minimum drying time must be adhered to.
Was this page helpful?