Interior mirror
In this manual: Interior mirror
2steps
~12min
1/5difficulty
Done 0 of 2
- Assembly overview - interior mirror
- Removing and installing interior mirror
Assembly overview - interior mirror
- Retaining plate for interior mirror
- To be renewed with windscreen only
- ⇒ General body repairs, exterior; Rep.
gr. 64 ; Windscreen; Removing and installing windscreen
- Rain and light sensor - G397-
- ⇒ Electrical system; Rep. gr. 92 ; Windscreen wiper system; Removing and installing rain and light sensor [G397]
- Bolt
- Qty. 2
- 1,5 N·m
- Spring clip
- Renew after removing
- Interior mirror
- ⇒ Rep. gr. 68 ; Removing and installing interior mirror
- Lower cover
- Upper cover
Removing and installing interior mirror
Removing
- Unclip lower cover -1- in rear area at every side in direction of -arrow A- using commercially available plastic wedge -2-.
- Remove lower cover -1- in direction of -arrow B-.

- Remove upper cover -1- in direction of -arrow-.

- Disconnect electrical connector -2-.
- Insert screwdriver -1- into gap.
- Turn interior mirror -3- at mirror base approx. 20º in direction of -arrow-, and pull it off downwards.

Installing
Reusing interior mirror
- Unscrew bolts -1-.
- Renew spring clip -2-.
- Screw in bolts -1- and tighten them.

All vehicles (continued)
- Make sure that the interior mirror is aligned parallel with the retaining plate.
- Fit interior mirror, turned in anti-clockwise direction, onto retaining plate.
- Turn interior mirror clockwise until it can be heard to engage.
Tightening torques
Further installation is carried out in reverse order of removal.
Observe the following when doing this:
- ⇒ Rep. gr. 68 ; Assembly overview - interior mirror
Was this page helpful?