Bulkhead
In this manual: Bulkhead
3steps
~18min
2/5difficulty
Done 0 of 3
- Assembly overview - bulkhead
- Removing and installing bulkhead
- Removing and installing plenum chamber cover
Assembly overview - bulkhead
- Bulkhead
- ⇒ Rep. gr. 50 ; Removing and installing bulkhead
- Nut
- 8 N·m
- Nut
- Depending on model
- Qty. 4
- 2 N·m

Assembly overview plenum chamber cover
- Plenum chamber cover
- ⇒ Rep. gr. 50 ; Removing and installing plenum chamber cover
- Plenum chamber side cover
- ⇒ Rep. gr. 50 ; Removing and installing plenum chamber cover
- Seal
- Windscreen seal
- Windscreen

Removing and installing bulkhead
Removing
- Pull off clamping washers -2-.
- Remove bulkhead insulation -3- in upper area of bulkhead -1-.

For remaining procedure, fresh air and air recirculation flap - VX96- must be closed. To assure this, proceed as follows:
- Switch on ignition.
- Close fresh air and air recirculation flap by pressing "air recirculation mode" button on display and control panel.
- Disconnect electrical connector -1-.
- Switch off ignition.

- Unscrew nuts -1-.

- Pull plenum chamber cover upwards, while simultaneously loosening retaining hooks -arrows- of cover -1- for fresh air intake -3-.
- Remove cover -1- for fresh air intake -3- from bulkhead -2-.

Installing
Install in reverse order of removal, observing the following:
- Inspect gasket of cover for fresh air intake for damage.
- Fit cover for fresh air intake, making sure that fasteners engage audibly.
Tightening torques
- ⇒ Rep. gr. 50 ; Assembly overview - bulkhead
Removing and installing plenum chamber cover
Removing
- Remove wiper arms ⇒ Electrical system; Rep. gr. 92 ; Windscreen wiper system; Removing and installing wiper arms .
- Pull off seal -3- along entire length of plenum chamber cover -1-.
- Push plenum chamber covers at side -2- in direction of -arrow A-, and pull out plenum chamber cover -1-.
- Pull plenum chamber cover -1- in direction of -arrow B- out of windscreen seal -4-.
- Remove plenum chamber cover -1- by guiding it over wiper arm shafts.
- Remove plenum chamber covers at side -2-.

Installing
Install in reverse order of removal, observing the following:
If windscreen has been renewed:
- Remove insert from windscreen seal.
All vehicles (continued)
NOTICE
Risk of windscreen damage from plenum chamber cover striking windscreen surround.
The windscreen may crack.
- Never strike plenum chamber cover or press in with aid of tool.
- Press plenum chamber cover into windscreen surround by hand while applying light pressure.
- Spray windscreen seal with a soapy solution so that plenum chamber cover is easier to press in.
- Position plenum chamber cover at windscreen seal, and align it centrally.
- Starting from outside, press plenum chamber cover into windscreen seal by applying light pressure
Was this page helpful?