Rear cross member
In this manual: Rear cross member
4steps
~24min
2/5difficulty
Done 0 of 4
Assembly overview - rear cross member
- Stop buffer mounting
- Left
- Rear cross member
- ⇒ Rep. gr. 53; Renewing rear cross member
- Web plate
- Stop buffer mounting
- Right
- Bonded area
- Separating cut

Renewing rear cross member
WARNING
Gases/vapours hazardous to health are generated when welding, soldering or cutting using tools which produce sparks in foam-treated areas.
- Do not weld, solder or cut closer than 15 mm to moulded foam inserts.
- Use an extraction system during work.
NOTICE
If separating cuts are made too deep, underlying reinforcement could be damaged.
- Only make separating cuts with body saw.
- Rewelding of reinforcements is not permitted due to safety reasons.
NOTICE
If welds are positioned too far on outside, strength could be impaired
- RP weld points must be placed as far as possible from outer edge of welding flange.
NOTICE
If adhesive is applied prematurely, bond could be impaired
- New part must be welded in within 90 minutes.
NOTICE
Observe safety information ⇒ Rep. gr. 00; Safety information Only tools and workshop equipment authorised by Volkswagen AG may be used ⇒ 2.1
Removing
- Separate original joint.

- Remove rear cross member -1-.
- Remove remaining material.

- Completely remove remaining adhesive.
- Grind bonding surfaces and welding surfaces back to bare metal and clean.
Installing
Replacement parts
- For allocation of 2-pack body adhesive, see ⇒ Electronic parts catalogue (ETKA)
Important
- New parts must be adapted and attached with the vehicle standing on its wheels or straightening bracket set.
- Lightly sand down bonding surfaces in area of web plates.

- Grind bonding surfaces and welding surfaces on new part -1- to -4- down to bare metal and clean.
- Drill 8 mm diameter holes for SG plug weld seam in new part -1-.
- Drill 8 mm diameter holes for weld studs -3- in new part -1-.
- Adapt weld studs -3- to fit and fix in position.
- Weld in weld studs -3-, SG continuous weld seam.
- Apply 2-component body adhesive to entirety of new part -2- and -4-.
- Adapt new part -2- and -4- to new part -1-, and fix in position.
- Weld in new part -2- and -4- on new part -1-, RP spot weld seam.
- Apply 2-component body adhesive to entire surface.

- Adapt new part -1- to fit and fix in position.

- Check fit with add-on parts.
- Weld in new part -1-, RP spot weld seam and SG plug weld seam.
- Weld separating cut for partial replacement, MIG solder seam or SG stepped weld seam are permitted.
Was this page helpful?