Electric drive motor
In this manual: Electric drive motor
~1min read
Removing and installing oil temperature sender -G8-
Removing
- Remove rear centre underbody cladding ⇒ General body repairs, exterior; Rep. gr. 66 ; Underbody cladding; Removing and installing rear centre underbody cladding .
- Drain gear oil ⇒ Rep. gr. 34 ; Gear oil; Draining and filling gear oil .
- Unscrew bolts -1-, and remove cover plate -2-.

- Disconnect electrical connector -arrow-.
- Unscrew bolt -2-.
- Pull out oil temperature sender - G8- -1-.

Installing
Install in reverse order of removal, observing the following:
- Fill gearbox oil ⇒ Rep. gr. 34 ; Gearbox oil; Draining and filling gearbox oil .
Tightening torques
- ⇒ Rep. gr. 10 ; Assembly overview - rear motor
Was this page helpful?