Making a flow-drill screw connection, pre-drilled hole in upper part
In this manual: Making a flow-drill screw connection, pre-drilled hole in upper part
~2min read
- Loosen flow-drill screw connection using socket for flow-drill screws.
- Remove upper part.
- Prepare connections for applying adhesive.
- Clean bonding surface with cleaning solution.
- Apply 2-pack epoxy adhesive to entire area.
- Position new part, and secure it by using socket for flow-drill screws to tighten new screws to 7 N·m.
Making a flow-drill screw connection, no pre-drilled hole in upper part
- Loosen flow-drill screw connection using socket for flow-drill screws.
- Remove upper part.
- Insert hole detectors in the existing FDS threads. Consider offset due to hole detectors: Eventually, perform marking for each area.
- Position new part.
- Use light blows of a rubber-headed hammer to carefully mark the holes in the new part.
- Remove upper part.
- Drill holes with Ø 7 mm in new part.
- Prepare connections for applying adhesive.
- Clean bonding surface with cleaning solution.
- Apply 2-pack epoxy adhesive to entire area.
- Position new part, and secure it by using socket for flow-drill screws to tighten new screws to 7 N·m.
Making a flow-drill screw connection, exchanging upper and lower parts
- Loosen flow-drill screw connection using socket for flow-drill screws.
- Remove both parts.
- Drill holes of 4 mm in diameter through both parts having the same distance to each other as in original joint.
- Remove new parts.
- Expand 4 mm holes in upper part to 7 mm in diameter.
- Prepare connections for applying adhesive.
- Clean bonding surface with cleaning solution.
- Apply 2-pack epoxy adhesive to entire area.
- Position new part, and secure it by using socket for flow-drill screws to tighten new screws to 7 N·m.
Renewing friction-element-welded joints
Friction element welding is used in multi-material body-in-white manufacturing to join ultra-high-strength steel with aluminium components. A distinction is made between standard friction elements and countersunk friction elements.
Was this page helpful?