Vehicle noise/engine sound
In this manual: Vehicle noise/engine sound
8steps
~48min
2/5difficulty
Done 0 of 8
- Overview of fitting locations - driving sound/motor sound
- Removing and installing engine sound generator module 1 [RX21] / module 2 [RX22]
Overview of fitting locations - driving sound/motor sound

- Engine sound generator module 2 - RX22-
- With actuator 2 for engine sound generator - R258-
- With engine sound generator control unit 2 - J1167-
- Depending on equipment/ version
- ⇒ Rep. gr. 93 ; Removing and installing engine sound generator module 2 [RX22]
- Bolt
- Qty. 3
- 8 N·m
- Electrical connector
- Nut
- 8 N·m
- Bracket
- Bolt
- Qty. 3
- 8 N·m
- Bracket
- Bolt
- Qty. 3
- 8 N·m
- Electrical connector
- Engine sound generator module 1 - RX21-
- With actuator 1 for engine sound generator - R257-
- With engine sound generator control unit - J943-
- ⇒ Rep. gr. 93 ; Removing and installing engine sound generator module 1 [RX21]
Removing and installing engine sound generator module 1 [RX21] / module 2 [RX22]
Removing and installing engine sound generator module 1 [RX21]
Removing
- Remove front underbody cladding ⇒ General body repairs, exterior; Rep. gr. 66 ; Underbody cladding; Removing and installing front underbody cladding .
- Remove front right wheel housing liner ⇒ General body repairs, exterior; Rep. gr. 66 ; Wheel housing liner; Removing and installing front wheel housing liner .
- Disconnect electrical connectors -4-.
- Unscrew nuts -2-.
- Remove engine sound generator module 1 - RX21- -1- from bracket -3-.
![Volkswagen ID.4. Removing and installing engine sound generator module 1 [RX21]](/media/volkswagen-id-4/353/images/manuals/353/volkswagen_id_4__rx22__2371.webp)
Installing
Install in reverse order of removal, observing the following:
Tightening torques
- ⇒ Rep. gr. 93 ; Overview of fitting locations - driving sound/ motor sound
Removing and installing engine sound generator module 2 [RX22]
Removing
- Remove rear underbody cladding ⇒ General body repairs, exterior; Rep. gr. 66 ; Underbody cladding; Removing and installing rear underbody cladding .
- Disconnect electrical connectors -4-.
- Unscrew nuts -3-.
- Remove engine sound generator module 2 - RX22- -1- from bracket -2-.
![Volkswagen ID.4. Removing and installing engine sound generator module 2 [RX22]](/media/volkswagen-id-4/353/images/manuals/353/volkswagen_id_4__rx22__2372.webp)
Installing
Install in reverse order of removal, observing the following:
Tightening torques
- ⇒ Rep. gr. 93 ; Overview of fitting locations - driving sound/ motor sound
Was this page helpful?