Periodic Maintenance
- Drive Belt
- Air Cleaner Filter
- Spark Plug
Drive Belt Nissan Pathfinder R53
Exploded View

| 1. | Drive belt auto-tensioner | 2. | Generator | 3. | Compressor |
| 4. | Drive belt | 5. | Crankshaft pulley | A. | Drive belt auto-tensioner indicator |
| B. | View B | C. | Possible use range | Engine front |
Checking Drive Belt
Visually check entire drive belt for wear, damage or cracks.
Check that the drive belt auto-tensioner indicator is within the possible use range.
If the drive belt auto-tensioner indicator is out of the possible use range or drive belt is damaged, replace drive belt.
Tension Adjustment
Drive belt tension is automatically adjusted by the drive belt auto-tensioner.
Drive belt tension is not manually adjustable.
Removal and Installation
REMOVAL
Remove the front wheel and tire (RH) using power tool. Refer to Removal and Installation.
Remove the front fender protector side cover (RH). Refer to Exploded View.
While securely holding the hexagonal part in pulley center of drive belt auto-tensioner, move in the direction of arrow (loosening direction of drive belt auto-tensioner) using suitable tool.

Insert a rod approximately 6 mm (0.24 in) in diameter through the rear of drive belt auto-tensioner into retaining boss to lock drive belt auto-tensioner pulley.
Remove drive belt from crankshaft pulley and then remove it from the other pulleys.
INSTALLATION
Install the drive belt onto all of the pulleys.
Release drive belt auto-tensioner, and apply tension to drive belt.
Turn crankshaft pulley clockwise several times to equalize tension between each pulley.
Confirm drive belt auto-tensioner indicator is within the possible use range. Refer to Checking Drive Belt.
Install the front fender protector side cover (RH). Refer to Exploded View.
Install the front wheel and tire (RH) using power tool. Refer to Removal and Installation.
Removal and Installation of Drive Belt Auto-tensioner

| 1. | Drive belt auto-tensioner |
REMOVAL
Remove the drive belt. Refer to Removal and Installation.
Remove the drive belt auto-tensioner.
INSTALLATION
Installation is in the reverse order of removal.
Air Cleaner Filter Nissan Pathfinder 2022
Exploded View

| 1. | Air duct hose and resonator assembly | 2. | Front air duct | 3. | Grommet |
| 4. | Air cleaner case mounting bracket | 5. | Bracket | 6. | Retainer |
| 7. | Mounting rubber | 8. | Air cleaner case (lower) | 9. | Air cleaner assembly |
| 10. | Air cleaner filter | 11. | Air cleaner case (upper) | A. | To electric throttle control actuator. Refer to Exploded View. |
| B. | To rocker cover (bank 1). Refer to Exploded View. |
Removal and Installation
REMOVAL
Unhook air cleaner case side clips and lift air cleaner case (upper).
Remove the air cleaner filter.
INSTALLATION
Installation is in the reverse order of removal.
Spark Plug Nissan Pathfinder Fifth generation
Exploded View

| 1. | Ignition coil | 2. | Spark plug | 3. | Rocker cover (Bank 1) |
| 4. | Rocker cover (Bank 2) |
Removal and Installation
REMOVAL
Remove the ignition coil. Refer to Removal and Installation (Bank 2) (Bank 2) and Removal and Installation (Bank 1) (Bank 1).
Remove the spark plug using Tool.

| Tool number | : — (NI-48891) |
INSPECTION AFTER REMOVAL
Use the standard type spark plug for normal condition.

| Spark plug | : Refer to Spark Plug. |
| Cleaner air pressure | : less than 588 kPa (5.88 bar, 6 kg/cm2, 85 psi) |
| Cleaning time | : less than 20 seconds |
Spark plug gap adjustment is not required between replacement intervals.

Measure spark plug gap. When it exceeds the limit, replace spark plug even if it is within the specified replacement mileage. Refer to Spark Plug.
INSTALLATION
Installation is in the reverse order of removal.