Symptom Diagnosis
- Combination Switch System Symptoms
- Normal Operating Condition
Combination Switch System Symptoms Nissan Ariya first Gen
Symptom Table
Perform “Data Monitor” of CONSULT to check for any malfunctioning item.
Check that the data monitor display switches in conjunction with the combination switch operation.
If there is a switch whose display does not change, specify the applicable combination switch circuit (INPUT 1 - 6 and OUTPUT 1 - 5) using the combination switch circuit confirmation table for the circuit used for that switch.
Example: If the circuit used for the switch corresponds to INPUT 1 and OUTPUT 2 of the combination switch circuit, but the other switches that use the INPUT 1 circuit are normal, it is determined that the INPUT 1 circuit is normal and inspection OUTPUT 2 circuit. If other switches that use OUTPUT 2 circuit are normal, the combination switch circuit (INPUT 1 and OUTPUT 2) is determined to be normal, and it can be determined that the combination switch is defective.
Circuit used: ×
Combination switch circuit confirmation table Data monitor item Combination switch circuit Sub system Data monitor item INPUT 1 INPUT 2 INPUT 3 INPUT 4 INPUT 5 INPUT 6 OUTPUT 1 OUTPUT 2 OUTPUT 3 OUTPUT 4 OUTPUT 5 COMB SW Check diode 1 × × High beam switch × × Passing switch × × Front fog switch × × INT volume 1 × × Check diode 2 × × Low beam switch × × AUTO light switch*1 × × Tail lamp switch × × Front washer switch × × Rear washer switch × × Check diode 3 × × Turn signal LH × × Turn signal RH × × Front wiper LO × × Front wiper HI × × Front wiper INT × × Check diode 4 × × Light OFF switch*2 × × INT volume 2 × × INT volume 3 × × Rear wiper INT × × Rear wiper ON × × Check diode 5 × × Front wiper OFF × × Front wiper MIST × × BCM High beam assist switch × × *2: “Light OFF switch” is indicated on CONSULT display, however this means lighting switch AUTO position on this Nissan Ariya vehicle. (Without lighting switch OFF position)
Identify the possible malfunctioning part from combination switch circuit confirmation table and inspection or replace it.
Possible malfunction part / Symptom Inspection / Replace Some data monitor displays do not switch There is a malfunction with either of the combination switch INPUT circuit Inspect the combination switch input circuit applicable to the malfunctioning part. Refer to Diagnosis Procedure. There is a malfunction with either of the combination switch OUTPUT circuit Inspect the combination switch output circuit applicable to the malfunctioning part. Refer to Diagnosis Procedure. It is not applicable to any of the combination switch INPUT circuit and OUTPUT circuit Replace combination switch. Refer to Removal and Installation.
If the data monitor display does not switch for a specific switch, the corresponding switch has a malfunction.All data monitor displays do not switch Replace BCM. Refer to Removal and Installation. All data monitor displays switch Check intermittent incident. Refer to Intermittent Incident.
Normal Operating Condition Nissan Ariya: FE0
Description
SHIPPING MODE
Shipping mode inhibits battery power consumption during transportation or storage of the Nissan Ariya vehicle. Vehicle is set to shipping mode before being shipped from the factory.
When power switch is OFF, BCM operates shipping mode.
For shipping mode cancel operation, refer to Work Procedure.