Since hybrid vehicles and electric vehicles contain a high voltage battery, there is the risk of electric shock, electric leakage, or similar accidents if the high voltage component and Nissan Ariya vehicle are handled incorrectly. Be sure to follow the correct work procedures when performing inspection and maintenance.
REMOVAL
Follow the instructions below before starting the procedure.
Use a refrigerant collecting equipment (for HFO-1234yf) to discharge the refrigerant. Refer to Recycle Refrigerant.
Remove high voltage power delivery assembly. Refer to HIGH VOLTAGE POWER DELIVERY ASSEMBLY : Removal & Installation.
Remove Front tire LH. Refer to ROAD WHEEL TIRE : Removal & Installation.
Remove front fender protector LH. Refer to Removal & Installation.
Disconnect high-pressure flexible hose from electric compressor. Refer to Removal & Installation.
Disconnect low-pressure flexible hose from electric compressor. Refer to Removal & Installation.
Remove mounting bolts , and then remove compressor stay.
:Nissan Ariya Vehicle front
Remove mounting bolt , and then remove high voltage harness from compressor bracket.
:Nissan Ariya Vehicle front
Remove mounting bolt of high voltage harness bracket.
Disconnect high voltage harness connector .
To prevent electric shock hazards, immediately wrap insulating tape around disconnected high voltage connector terminals.
Disconnect high voltage harness connector according to numerical order 1→5 indicated by arrows as shown in the figure.
Disconnect low voltage harness connector .
Remove lower side mounting bolts of electric compressor.
:Nissan Ariya Vehicle front
Completely loosen electric compressor upper side mounting bolt .
Remove electric compressor and electric compressor upper side mounting bolt as a set from Nissan Ariya vehicle.
INSTALLATION
Note the following items, and then install in the reverse order of removal.
Inspection
EQUIPOTENTIAL TEST
After installing the electric compressor, measure the resistance below.
Between electric compressor (aluminum part) and body (ground bolt).
Between electric compressor (aluminum part) and traction motor inverter.
Standard
: Less than 0.1 Ω
If the result deviates from the standard value, check for paint, oil, dirt, or other substance adhering to the bolts or conductive mounting parts. If such substances are found, clean the surrounding area and remove foreign substances.
Compressor Bracket Nissan Ariya: FE0
Removal & Installation
DANGER:
Since hybrid vehicles and electric vehicles contain a high voltage battery, there is the risk of electric shock, electric leakage, or similar accidents if the high voltage component and Nissan Ariya vehicle are handled incorrectly. Be sure to follow the correct work procedures when performing inspection and maintenance.
REMOVAL
Follow the instructions below before starting the procedure.
Use a refrigerant collecting equipment (for HFO-1234yf) to discharge the refrigerant. Refer to Recycle Refrigerant.
Remove electric compressor. Refer to Removal & Installation.
Remove mounting bolt , and then remove high voltage harness from compressor bracket.
:Nissan Ariya Vehicle front
Remove mounting bolt , and then remove ground wire from compressor bracket.
Remove mounting bolts and , remove compressor bracket.
:Nissan Ariya Vehicle front
INSTALLATION
Note the following items, and then install in the reverse order of removal.