Hood Lock
Exploded View

| Hood lock assembly | Hood lock control cable assembly | Hood lock control handle | |||
| : Clip | |||||
| : Pawl | |||||
| : N·m (kg-m, in-lb) | |||||
| : Body grease | |||||
- Hood Lock
- Hood Lock Control Handle
- Hood Lock Control Cable
Hood Lock Nissan Ariya 1st generation
Removal & Installation
REMOVAL
Disconnect hood lock assembly harness connector (if equipped).
Remove hood lock assembly mounting bolts, and then remove hood lock.
Disconnect hood lock control cable assembly from hood lock assembly according to the numerical order 1→2 indicated by arrows as shown in figure.

INSTALLATION
Note the following items, and then install in the reverse order of removal.
Inspection
Check that operating force of hood lock control handle shall be less than 49 N (5.0 kg, 11.0 lb).
Check pitch that secondary latch
is properly engaged with striker
[8.1mm (0.319 in) MIN] (D).

While operating the hood lock control handle carefully, check that the front end of the hood is lifted by approximately 20 mm (0.787 in) (C). Also, check that the hood lock control handle returns to the original position.

| Striker | Primary latch |
Check that primary latch
is securely engaged with striker
when hood assembly is closed [free-fall from approximately 200mm (7.874 in) height].

Check the hood lock assembly lubrication condition. If necessary, apply body grease to hood lock assembly.

| : Body grease |
Hood Lock Control Handle Nissan Ariya: FE0
Removal & Installation
REMOVAL
Disengage hood lock control handle fixing pawl, and then remove hood lock control handle.

| : Pawl |
INSTALLATION
Note the following items, and then install in the reverse order of removal.
Hood Lock Control Cable Nissan Ariya SUV
Removal & Installation
REMOVAL
Remove front grill. Refer to Removal & Installation.
Disconnect hood lock control cable assembly from hood lock assembly. Refer to Removal & Installation.
Remove hood lock control handle. Refer to Removal & Installation.
Remove dash side finisher LH. Refer to Removal & Installation.
Remove hood lock control cable assembly mounting bolt.
Remove front fender protector LH. Refer to Removal & Installation.
Disengage hood lock control cable assembly fixing clips.
Remove grommet of the lower dash, and pull the hood lock control cable toward inside Nissan Ariya vehicle.
INSTALLATION
Note the following items, and then install in the reverse order of removal.