Symptom Diagnosis
- Wiper and Washer System Symptoms. With Light & Rain Sensor
- Front Wiper Does Not Operate
- Normal Operating Condition
Wiper and Washer System Symptoms. With Light & Rain Sensor Nissan Ariya: FE0
Symptom Table
| Symptom | Possible cause | Inspection item | |
|---|---|---|---|
| Front wiper does not operate | HI only |
|
|
| LO and AUTO |
|
|
|
| LO only |
|
Combination switch Refer to Removal and Installation. |
|
| AUTO only |
|
|
|
| HI, LO and AUTO |
|
SYMPTOM DIAGNOSIS Refer to Diagnosis Procedure. |
|
| Front wiper does not stop | HI only |
|
|
| LO only |
|
Combination switch Refer to Removal and Installation. |
|
| AUTO only |
|
|
|
| Front wiper does not operate normally | Sensitivity adjustment cannot be performed |
|
Combination switch Refer to Removal and Installation. |
| Auto wiping operation does not operate |
|
|
|
| Wiper is not linked to the washer operation |
|
Combination switch Refer to Removal and Installation. |
|
| Does not return to stop position [Repeatedly operates for 10 seconds and then stops for 20 seconds. After that, it stops the operation. (Fail-safe)] |
|
Front wiper stop position signal circuit Refer to Diagnosis Procedure. |
|
| Front washer does not operate normally |
|
|
|
| Rear wiper does not operate | ON only |
|
Combination switch Refer to Removal and Installation. |
| INT only |
|
Combination switch Refer to Removal and Installation. |
|
| ON and INT |
|
Combination switch Refer to Removal and Installation. |
|
| Rear wiper does not stop | ON only |
|
Combination switch Refer to Removal and Installation. |
| INT only |
|
Combination switch Refer to Removal and Installation. |
|
| Rear wiper does not operate normally | Wiper is not linked to the washer operation |
|
Combination switch Refer to Removal and Installation. |
| Rear wiper does not operate even when shift position is “R”. | Rear wiper operation linked with reverse setting | Check the rear wiper operation linked with reverse setting by combination meter. | |
| Rear washer does not operate normally |
|
|
|
| Washer fluid warning does not operate normally |
|
Washer level switch Refer to Diagnosis Procedure. |
|
Front Wiper Does Not Operate Nissan Ariya first Gen
Diagnosis Procedure
The front wiper does not operate under any operation conditions.
CHECK FRONT WIPER REQUEST SIGNAL INPUT
CONSULT DATA MONITOR
Power switch ON.
Select “Front wiper request” of “IPDM E/R” data monitor item.
Switch the front wiper switch to HI and LO.
With operating the front wiper switch, check the status of “FR WIPER REQ”.
Monitor item Condition Monitor status Front wiper request Front wiper switch HI High LO Low INT OFF Return
Is the inspection result normal?
YES>>GO TO 2.
NO>>GO TO 6.
CHECK WIPER RELAY OPERATION
Switch the front wiper switch to HI and LO, check front wiper operation.
Is front wiper operation normally?
YES>>INSPECTION END
NO - 1>>HI and LO does not operate :GO TO 3.
NO – 2>>HI only does not operate :Refer to Diagnosis Procedure.
NO – 3>>LO only does not operate :Refer to Diagnosis Procedure.
CHECK FRONT WIPER MOTOR FUSE
Power switch OFF.
Check that the following fuse is not blown (open).
Location No. Capacity IPDM E/R 138 30 A
Is the fuse blown (open)?
YES>>Replace the blown (open) fuse after repairing the cause of blown (open).
NO>>GO TO 4.
CHECK FRONT WIPER MOTOR GROUND CIRCUIT
Check front wiper motor ground circuit. Refer to Diagnosis Procedure.
Is the inspection result normal?
YES>>Replace front wiper motor. Refer to Removal & Installation.
NO>>GO TO 5.
CHECK INTERMITTENT INCIDENT
Check intermittent incident. Refer to Intermittent Incident.
Is the inspection result normal?
YES>>Replace IPDM E/R. Refer to Removal and Installation.
NO>>Repair or replace harness.
CHECK COMBINATION SWITCH
Perform the inspection of the combination switch. Refer to Symptom Table.
Is combination switch normal?
YES>>Replace BCM. Refer to Removal and Installation.
NO>>Replace combination switch. Refer to Removal and Installation.
Normal Operating Condition Nissan Ariya SUV
Symptom Description
FRONT WIPER MOTOR PROTECTION FUNCTION
IPDM E/R may stop the front wiper to protect the front wiper motor if any obstruction (operation resistance) such as a large amount of snow is detected during the front wiper operation.
At that time turn OFF the front wiper and remove the foreign object. Then reactivate the front wiper. The wiper will operate normally.
REAR WIPER MOTOR PROTECTION FUNCTION
BCM may stop rear wiper to protect the rear wiper motor when the rear wiper is stopped for 5 seconds or more due to a snowfall.
Rear wiper operates normally 1 minute after the obstacles are removed with rear wiper OFF.