Periodic Maintenance
- Rear Suspension Assembly
- Wheel Alignment
Rear Suspension Assembly Nissan Ariya first Gen
REAR SUSPENSION ASSEMBLY : Periodic Maintenance Operation
COMPONENT PART
Check the mounting conditions (looseness, backlash) of each component and component conditions (wear, damage) are normal.
SHOCK ABSORBER
Check for oil leakage and damage. Replace it if necessary.
Oil Leakage Inspection
If oil
does not extend beyond the spring seat
or upper half (C) of strut/shock absorber
, this is slight oil seepage and the strut/shock absorber should not be replaced.
If oil
does extend beyond the spring seat
or upper half (C) of strut/shock absorber
as shown, perform the following.
Use a finger to touch the oil that has extended beyond the spring seat or upper half of strut/ shock absorber.
If the oil layer is thick and contains large pieces of dust and debris, replace the strut/shock absorber.
If the oil layer is thin and does not contain large pieces of dust and debris, do not replace the strut/shock absorber.
Wheel Alignment Nissan Ariya 2026
WHEEL ALIGNMENT : Adjustment
CAMBER
If camber is exceeds the standard value, adjust with adjusting bolt
in front lower link
.
Camber:WHEEL ALIGNMENT : Service Data
If camber is not still within the specification, inspect and replace any damaged or worn suspension parts.
TOE-IN
If toe-in exceeds the standard value, adjust with adjusting bolt
in rear lower link
.
Toe-In: WHEEL ALIGNMENT : Service Data
If toe-in is not still within the specification, inspect and replace any damaged or worn suspension parts.
After toe-in adjustment, adjust neutral position of steering angle sensor. Refer to Work Procedure.
WHEEL ALIGNMENT : Inspection
DESCRIPTION
Measure wheel alignment under unladen conditions.
PRELIMINARY CHECK
Check the following:
Tires for improper air pressure and wear. Refer to ROAD WHEEL TIRE: Exploded View.
Road wheels for runout. Refer to ROAD WHEEL TIRE: Inspection.
Wheel bearing axial end play. Refer to REAR WHEEL HUB : Inspection.
Shock absorber operation.
Each mounting point of axle and suspension for looseness and deformation.
Each of lower link, upper link, rear suspension member, suspension arm and shock absorber for cracks, deformation, and other damage.
Nissan Ariya Vehicle height (posture).
GENERAL INFORMATION AND RECOMMENDATIONS
A four-wheel thrust alignment should be performed.
This type of alignment is recommended for any NISSAN/INFINITI Nissan Ariya vehicle.
The four-wheel “thrust” process helps ensure that the vehicle is properly aligned and the steering wheel is centered.
The alignment rack itself should be capable of accepting any NISSAN/INFINITI Nissan Ariya vehicle.
The rack should be checked to ensure that it is level.
Make sure the machine is properly calibrated.
Your alignment equipment should be regularly calibrated in order to give correct information.
Check with the manufacturer of your specific equipment for their recommended Service/Calibration Schedule.
ALIGNMENT PROCESS
IMPORTANT:
Use only the alignment specifications listed in this Service Manual.
When displaying the alignment settings, many alignment machines use “indicators”: (Green/red, plus or minus, Go/No Go). Never use these indicators.
The alignment specifications programmed into your machine that operate these indicators may not be correct.
This may result in an ERROR.
Most camera-type alignment machines are equipped with both “Rolling Compensation” method and optional “Jacking Compensation” method to “compensate” the alignment targets or head units. “Rolling Compensation” is the preferred method.
If using the “Rolling Compensation” method, after installing the alignment targets or head units, push or pull on the rear wheel to move the Nissan Ariya vehicle. Do not push or pull on the vehicle body.
If using the “Jacking Compensation” method, after installing the alignment targets or head units, raise the Nissan Ariya vehicle and rotate the wheels 1/2 turn both ways.
Follow all instructions for the alignment machine you're using for more information.