Periodic Maintenance
- Front Suspension Assembly
- Wheel Alignment
Front Suspension Assembly Nissan Ariya 1st generation
FRONT SUSPENSION ASSEMBLY : Periodic Maintenance Operation
COMPONENT PART
Check the front suspension for the following:
Check each component for looseness or play.
Inspect each component for abnormal wear or damage.
Ball Joint Axial End Play

Set front wheels in a straight-ahead position.
Check ball joint boot for cracks or other damage. If there are cracks or other damage, replace transverse link.
Move axle side of transverse link up and down by hand. Check there is no end play.

STRUT ASSEMBLY
Oil Leakage Inspection
If oil
does not extend beyond the spring seat
or upper half (C) of strut/shock absorber
, this is slight oil seepage and the strut/shock absorber should not be replaced.
If oil
does extend beyond the spring seat
or upper half (C) of strut/shock absorber
as shown, perform the following.
– Use a finger to touch the oil that has extended beyond the spring seat or upper half of strut/shock absorber.
– If the oil layer is thick and contains large pieces of dust and debris, replace the strut/shock absorber.
– If the oil is thin and does not contain large pieces of dust and debris, do not replace the strut/shock absorber.
Wheel Alignment Nissan Ariya: FE0
WHEEL ALIGNMENT : Inspection
DESCRIPTION
Measure wheel alignment under unladen conditions.
PRELIMINARY CHECK
Check the following:
Tires for improper air pressure. Refer to ROAD WHEEL : Service Data.
Tires for improper wear.
Road wheels for runout. Refer to ROAD WHEEL TIRE : Inspection.
Wheel bearing axial end play. Refer to FRONT WHEEL HUB AND KNUCKLE : Inspection.
Transverse link ball joint axial end play. Refer to TRANSVERSE LINK : Inspection.
Strut operation.
Each mounting part of axle and suspension for looseness and deformation.
Each of suspension member, strut assembly and transverse link for cracks, deformation and other damage.
Nissan Ariya Vehicle height (posture).
GENERAL INFORMATION AND RECOMMENDATIONS
A four-wheel thrust alignment should be performed.
This type of alignment is recommended for any NISSAN/INFINITI Nissan Ariya vehicle.
The four-wheel “thrust” process helps ensure that the vehicle is properly aligned and the steering wheel is centered.
The alignment rack itself should be capable of accepting any NISSAN/INFINITI Nissan Ariya vehicle.
The rack should be checked to ensure that it is level.
Check the machine is properly calibrated.
Your alignment equipment should be regularly calibrated in order to give correct information.
Check with the manufacturer of your specific equipment for their recommended Service/Calibration Schedule.
ALIGNMENT PROCESS
IMPORTANT:
Use only the alignment specifications listed in this Service Manual.
When displaying the alignment settings, many alignment machines use “indicators” : (Green/red, plus or minus, Go/No Go). Never use these indicators.
The alignment specifications programmed into your machine that operate these indicators may not be correct.
This may result in an ERROR.
Most camera-type alignment machines are equipped with both “Rolling Compensation” method and optional “Jacking Compensation” method to “compensate” the alignment targets or head units. “Rolling Compensation” is the preferred method.
If using the “Rolling Compensation” method, after installing the alignment targets or head units, push or pull on the rear wheel to move the Nissan Ariya vehicle. Do not push or pull on the vehicle body.
If using the “Jacking Compensation” method, after installing the alignment targets or head units, raise the Nissan Ariya vehicle and rotate the wheels 1/2 turn both ways.
Follow all instructions for the alignment machine you're using for more information.
WHEEL ALIGNMENT : Adjustment
TOE-IN
Loosen the steering outer socket, and then adjust the length using steering inner socket.
| Toe-in: | WHEEL ALIGNMENT : Service Data |
After toe-in adjustment, adjust neutral position of steering angle sensor.
Adjust neutral position of steering angle sensor: Refer to Work Procedure.