Periodic Maintenance. Road Wheels & Tires
ROAD WHEEL TIRE : Adjustment
Aluminum Wheel
PREPARATION BEFORE ADJUSTMENT
Using releasing agent, remove double-faced adhesive tape from the road wheel.
ADJUSTMENT
The details of the adjustment procedure are different for each model of wheel balancer. Therefore, refer to each instruction manual.
If a tire balance machine has adhesion balance weight mode settings and drive-in weight mode setting, select and adjust a drive-in weight mode suitable for aluminum wheels.
Set road wheel on tire balance machine using the center hole as a guide. Start the tire balance machine.
When inner and outer unbalance values are shown on the tire balance machine indicator, multiply outer unbalance value by 5/3 to determine balance weight that should be used. Select the outer balance weight with a value closest to the calculated value above and install to the designated outer position of, or at the designated angle in relation to the road wheel.
Indicated unbalance value × 5/3 = balance weight to be installed
Calculation example:
23 g (0.81 oz) × 5/3 = 38.33 g (1.35 oz) ⇒ 40 g (1.41 oz) balance weight (closer to calculated balance weight value)
Example:
37.4 ⇒ 35 g (1.23 oz)
37.5 ⇒ 40 g (1.41 oz)
Installed balance weight in the position.When installing balance weight
to road wheels, set it into the grooved area
on the inner wall of the road wheel as shown in the figure so that the balance weight center
is aligned with the tire balance machine indication position (angle)
.

Start the tire balance machine again.
Install drive-in balance weight on inner side of road wheel in the tire balance machine indication position (angle).
Start the tire balance machine. Check that the inner and outer residual unbalance value is within the allowable unbalance value.
| Allowable unbalance value | |
| Dynamic (At flange) | Refer to Service Data |
| Static (At flange) | Refer to Service Data |
ROAD WHEEL TIRE : Inspection
APPEARANCE
Road Wheel
Check road wheel for deformation, cracks, corrosion and other damage.
Check wheel nuts for looseness by using torque wrench.
Wheel nut tightening torque : Refer to Exploded View.
TIRE
Check entire circumference and both sides of each tire for deformation, cracks, scratch and other damage.
Check tire tread for wear and foreign matter such as nails and small rock.
Check that tire pressure is the specified value.
Tire pressure : Refer to Service Data
ROAD WHEEL TIRE : Rotation
Follow the maintenance schedule for tire rotation service intervals. Refer to General Maintenance.

When installing the wheel, tighten wheel nuts to the specified torque. Refer to Exploded View.
After tire rotation, perform following:
Perform the ID registration.