2zr-fxe Auxiliary Battery
- Removal
- Installation
Removal
REMOVAL
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during auxiliary battery removal/installation are shown below.
HINT:
When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is drivenEffect/Inoperative Function when Necessary Procedure not Performed | Necessary Procedure | Link |
|---|---|---|
Front Camera System |
Drive the vehicle straight ahead at 35 km/h or more for 5 seconds or more. |
Effect/Inoperative Function when Necessary Procedure not Performed | Necessary Procedure | Link |
|---|---|---|
| *1: w/o Power Back Door System *2: w/ Power Back Door System |
||
Power Door Lock Control System*1
|
Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. |
|
Power Back Door System*2 |
Reset back door close position |
|
Air Conditioning System |
After the ignition switch is turned to ON, the servo motor standard position is recognized. |
- |
Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
1 |
PRECAUTION |
- |
- |
- |
|
2 |
NEGATIVE AUXILIARY BATTERY TERMINAL |
- |
- |
- |
- |
3 |
POSITIVE AUXILIARY BATTERY TERMINAL |
- |
- |
- |
- |
4 |
NO. 2 BATTERY CLAMP |
74482 |
- |
- |
- |
5 |
AUXILIARY BATTERY |
- |
- |
- |
- |
PROCEDURE
1. PRECAUTION
![]() |
NOTICE:
|
2. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
3. DISCONNECT CABLE FROM POSITIVE AUXILIARY BATTERY TERMINAL
4. REMOVE NO. 2 BATTERY CLAMP
5. REMOVE AUXILIARY BATTERY

Installation
INSTALLATION
COMPONENTS (INSTALLATION)
Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
1 |
AUXILIARY BATTERY |
- |
- |
- |
- |
2 |
NO. 2 BATTERY CLAMP |
74482 |
- |
- |
- |
3 |
POSITIVE AUXILIARY BATTERY TERMINAL |
- |
- |
- |
- |
4 |
NEGATIVE AUXILIARY BATTERY TERMINAL |
- |
- |
- |
- |
5 |
INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL |
- |
- |
- |
|
![]() |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) |
![]() |
N*m (kgf*cm, ft.*lbf): Specified torque |
PROCEDURE
1. INSTALL AUXILIARY BATTERY
2. INSTALL NO. 2 BATTERY CLAMP
Torque:
15,4 N·m {157 kgf·cm, 11 ft·lbf}
3. CONNECT CABLE TO POSITIVE AUXILIARY BATTERY TERMINAL
Torque:
5,4 N·m {55 kgf·cm, 48 in·lbf}
4. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
Torque:
5,4 N·m {55 kgf·cm, 48 in·lbf}
5. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL
HINT:
When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.
Click here
![]()













