Power Back Door Closer Switch
- Removal
- Inspection
- Installation
Removal
REMOVAL
COMPONENTS (REMOVAL)
Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
1 |
GLIDE DOOR INSIDE HANDLE BASE ASSEMBLY |
69290G |
- |
- |
|
2 |
NO. 1 POWER BACK DOOR CONTROL SWITCH |
84966A |
- |
- |
- |
PROCEDURE
1. REMOVE GLIDE DOOR INSIDE HANDLE BASE ASSEMBLY
![]() |
Click here |
2. REMOVE NO. 1 POWER BACK DOOR CONTROL SWITCH

![]() |
Remove in this Direction |
- |
- |
Inspection
INSPECTION
PROCEDURE
1. INSPECT NO. 1 POWER BACK DOOR CONTROL SWITCH
(a) Check the switch. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance:
If the result is not as specified, replace the No. 1 power back door control switch. |
|
(b) Check the switch illumination.
(1) Apply auxiliary battery voltage to the switch connector and check that the No. 1 power back door control switch illuminates.
OK:
Tester Connection | Condition | Specified Condition |
|---|---|---|
Auxiliary battery positive ( ) → Terminal W2-6 (ILL ) Auxiliary battery negative (-) → Terminal W2-1 (ILL-) |
Always |
Switch illumination illuminates |
If the result is not as specified, replace the No. 1 power back door control switch.
Installation
INSTALLATION
COMPONENTS (INSTALLATION)
Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
1 |
NO. 1 POWER BACK DOOR CONTROL SWITCH |
84966A |
- |
- |
- |
2 |
GLIDE DOOR INSIDE HANDLE BASE ASSEMBLY |
69290G |
- |
- |
- |
PROCEDURE
1. INSTALL NO. 1 POWER BACK DOOR CONTROL SWITCH
2. INSTALL GLIDE DOOR INSIDE HANDLE BASE ASSEMBLY









