Washer Nozzle (for Front Side)
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT WASHER NOZZLE SUB-ASSEMBLY
(a) Operate the washer nozzle sub-assemblies and check the position that the washer fluid contacts the windshield.
Standard:
Center of washer fluid contacts the windshield in the areas shown in the illustration.

*a |
Toyota Prius Vehicle center line |
- |
- |
![]() |
Measurement |
- |
- |
Standard Measurement:
Area | Measurement | Area | Measurement |
|---|---|---|---|
A |
309.6 mm (12.2 in.) |
B |
156.7 mm (6.17 in.) |
C |
87.7 mm (3.45 in.) |
- |
- |
HINT:
If the result is not as specified, replace the washer nozzle sub-assembly.
Removal
REMOVAL
COMPONENTS (REMOVAL)
Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
1 |
WASHER NOZZLE SUB-ASSEMBLY |
85035 |
- |
- |
|
● |
Non-reusable part |
- |
- |
PROCEDURE
1. REMOVE WASHER NOZZLE SUB-ASSEMBLY

![]() |
Remove in this Direction (1) |
![]() |
Remove in this Direction (2) |
(1) Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws as shown in the illustration to separate the washer nozzle sub-assembly.
(2) Disconnect the washer hose to remove the washer nozzle sub-assembly.
(b) Use the same procedure for the RH side and LH side.
Installation
INSTALLATION
COMPONENTS (INSTALLATION)
Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
1 |
WASHER NOZZLE SUB-ASSEMBLY |
85035 |
- |
- |
- |
2 |
INSPECT WASHER NOZZLE SUB-ASSEMBLY |
- |
- |
- |
|
3 |
ADJUST WASHER NOZZLE SUB-ASSEMBLY |
- |
- |
- |
|
● |
Non-reusable part |
- |
- |
PROCEDURE
1. INSTALL WASHER NOZZLE SUB-ASSEMBLY
2. INSPECT WASHER NOZZLE SUB-ASSEMBLY
![]() |
Click here |
3. ADJUST WASHER NOZZLE SUB-ASSEMBLY
Click here ![]()
Adjustment
ADJUSTMENT
PROCEDURE
1. REMOVE WASHER NOZZLE SUB-ASSEMBLY
Click here ![]()
2. ADJUST WASHER NOZZLE SUB-ASSEMBLY
(a) Select a washer nozzle sub-assembly so that the position the washer fluid hits the windshield will be within the standard area. Replace the washer nozzle sub-assembly with the selected one.

*a |
Washer Fluid Spray Angle |
*b |
Part Number |
3. INSTALL WASHER NOZZLE SUB-ASSEMBLY
Click here ![]()












