Charge Lid Light
Removal
REMOVAL
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during spot light assembly removal/installation are shown below.
CAUTION:
- Orange wire harnesses and connectors indicate high-voltage circuits. To prevent electric shock, always follow the procedure described in the repair manual.

Click here

- To prevent electric shock, wear insulated gloves when working on wire harnesses and components of the high voltage system.

NOTICE:
After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal.
Click here ![]()
HINT:
When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when Toyota Prius vehicle is drivenEffect/Inoperative Function when Necessary Procedure not Performed | Necessary Procedure | Link |
|---|---|---|
Front Camera System |
Drive the Toyota Prius vehicle straight ahead at 35 km/h or more for 5 seconds or more. |
Effect/Inoperative Function when Necessary Procedure not Performed | Necessary Procedure | Link |
|---|---|---|
| *1: w/o Power Back Door System *2: w/ Power Back Door System |
||
Power Door Lock Control System*1
|
Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. |
|
Power Back Door System*2 |
Reset back door close position |
|
Air Conditioning System |
for HEV Model:
|
- |

Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
1 |
BATTERY CHARGER CONNECTOR OPENING LID SUB-ASSEMBLY |
58409E |
- |
- |
- |
2 |
CHARGE LID LOCK WITH MOTOR ASSEMBLY |
77030B |
- |
- |
- |
3 |
SPOT LIGHT ASSEMBLY |
81360N |
- |
- |
|
PROCEDURE
1. REMOVE BATTERY CHARGER CONNECTOR OPENING LID SUB-ASSEMBLY
Click here ![]()
2. REMOVE CHARGE LID LOCK WITH MOTOR ASSEMBLY
Click here ![]()
3. REMOVE SPOT LIGHT ASSEMBLY

(1) Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws to remove the spot light assembly.
Inspection
INSPECTION
PROCEDURE
1. INSPECT SPOT LIGHT ASSEMBLY
(a) Check the spot light assembly.
(1) Apply auxiliary battery voltage to the connector and check the light illumination conditions. OK:
HINT: If the result is not as specified, replace the spot light assembly. |
|
Installation
INSTALLATION
COMPONENTS (INSTALLATION)
Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
1 |
SPOT LIGHT ASSEMBLY |
81360N |
- |
- |
- |
2 |
CHARGE LID LOCK WITH MOTOR ASSEMBLY |
77030B |
- |
- |
- |
3 |
BATTERY CHARGER CONNECTOR OPENING LID SUB-ASSEMBLY |
58409E |
- |
- |
- |
PROCEDURE
1. INSTALL SPOT LIGHT ASSEMBLY
2. INSTALL CHARGE LID LOCK WITH MOTOR ASSEMBLY
3. INSTALL BATTERY CHARGER CONNECTOR OPENING LID SUB-ASSEMBLY
Click here ![]()










