Hv Battery Heater (for Phev Model)
Removal
REMOVAL
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during No. 1 traction battery heater removal/installation are shown below.
CAUTION:
- Orange wire harnesses and connectors indicate high-voltage circuits. To prevent electric shock, always follow the procedure described in the repair manual.

Click here

- To prevent electric shock, wear insulated gloves when working on wire harnesses and components of the high voltage system.

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.
Click here ![]()
HINT:
When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Items for which learning is completed by driving the Toyota Prius vehicleEffect/Inoperative Function when Necessary Procedure not Performed | Necessary Procedure | Link |
|---|---|---|
Front Camera System |
Drive the Toyota Prius vehicle straight ahead at 35 km/h or more for 5 seconds or more. |
Effect/Inoperative Function when Necessary Procedure not Performed | Necessary Procedure | Link |
|---|---|---|
| *1: w/o Power Back Door System *2: w/ Power Back Door System |
||
Power Door Lock Control System*1
|
Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. |
|
Power Back Door System*2 |
Reset back door close position |
|
Air Conditioning System |
After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. |
- |

Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
1 |
NO. 1 TRACTION BATTERY COOLER CONDUCTOR |
- |
- |
- |
- |
2 |
NO. 1 TRACTION BATTERY COOLER SHEET |
G96NA |
- |
- |
- |
3 |
NO. 1 TRACTION BATTERY HEATER |
04G9H |
- |
- |
- |
*a |
Parts requiring replacement with new ones when replacing the No. 1 traction battery heater and No. 1 traction battery heater |
- |
- |
● |
Non-reusable part |
- |
- |
PROCEDURE
1. REMOVE NO. 1 TRACTION BATTERY COOLER CONDUCTOR
Click here ![]()
2. REMOVE NO. 1 TRACTION BATTERY COOLER SHEET
Click here ![]()
3. REMOVE NO. 1 TRACTION BATTERY HEATER

Installation
INSTALLATION
COMPONENTS (INSTALLATION)
Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
1 |
NO. 1 TRACTION BATTERY HEATER |
G96H1 |
- |
- |
- |
2 |
NO. 1 TRACTION BATTERY COOLER SHEET |
G96NA |
- |
- |
|
3 |
NO. 1 TRACTION BATTERY COOLER CONDUCTOR |
- |
- |
- |
|
*a |
Parts requiring replacement with new ones when replacing the No. 1 traction battery heater and No. 2 traction battery heater |
- |
- |
● |
Non-reusable part |
- |
- |
PROCEDURE
1. INSTALL NO. 1 TRACTION BATTERY HEATER
2. INSTALL NO. 1 TRACTION BATTERY COOLER SHEET
![]() |
Click here |
3. INSTALL NO. 1 TRACTION BATTERY COOLER CONDUCTOR
Click here ![]()











