Automatic Light Control Sensor
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT AUTOMATIC LIGHT CONTROL SENSOR
Pre-procedure1
(a) Disconnect the G1 automatic light control sensor connector.
Procedure1
(b) Measure the voltage and resistance according to the value(s) in the table below.
Standard Voltage:
Tester Connection | Condition | Specified Condition | Result |
|---|---|---|---|
G1-1 (CLTB) - G1-2 (CLTE) |
Ignition switch off |
Below 1 V |
V |
G1-1 (CLTB) - G1-2 (CLTE) |
Ignition switch on (IG) |
11 to 14 V |
V |
Standard Resistance:
Tester Connection | Condition | Specified Condition | Result |
|---|---|---|---|
G1-2 (CLTE) - Body ground |
Always |
Below 1 Ω |
Ω |
If the result is not as specified, there may be a malfunction on the wire harness side.
Post-procedure1
(c) Connect the G1 automatic light control sensor connector.
Procedure2
(d) Connect an oscilloscope to terminals G1-2 (CLTE) and G1-4 (CLTS) of the automatic light control sensor connector and check the waveform.

*a |
Component with harness connected (Automatic Light Control Sensor) |
*b |
Waveform |
OK:
Tester Connection | Condition | Tool Setting | Specified Condition |
|---|---|---|---|
G1-2 (CLTE) - G1-4 (CLTS) |
Ignition switch on (IG) |
2 V/DIV., 10 ms./DIV. |
Pulse generation (See waveform) |
HINT:
The communication waveform changes according to the surrounding brightness.
If the result is not as specified, the automatic light control sensor may be malfunctioning.
Removal
REMOVAL
COMPONENTS (REMOVAL)
Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
1 |
INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY |
- |
- |
- |
- |
2 |
AUTOMATIC LIGHT CONTROL SENSOR |
89120A |
- |
- |
- |
PROCEDURE
1. REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
Click here
![]()
2. REMOVE AUTOMATIC LIGHT CONTROL SENSOR

Installation
INSTALLATION
COMPONENTS (INSTALLATION)
Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
1 |
AUTOMATIC LIGHT CONTROL SENSOR |
89120A |
- |
- |
- |
2 |
INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY |
- |
- |
- |
- |
PROCEDURE
1. INSTALL AUTOMATIC LIGHT CONTROL SENSOR
2. INSTALL INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
Click here ![]()





