Crankshaft Position Sensor
Removal
REMOVAL
COMPONENTS (REMOVAL)
Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
1 |
REAR ENGINE UNDER COVER RH |
51443C |
- |
- |
- |
2 |
CRANKSHAFT POSITION SENSOR |
11401G |
- |
- |
|
PROCEDURE
1. REMOVE REAR ENGINE UNDER COVER RH

2. REMOVE CRANKSHAFT POSITION SENSOR
![]() |
NOTICE: If the crankshaft position sensor has been struck or dropped, replace it. |

Installation
INSTALLATION
COMPONENTS (INSTALLATION)
Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
1 |
CRANKSHAFT POSITION SENSOR |
11401G |
- |
- |
|
2 |
INSPECT FOR ENGINE OIL LEAK |
- |
- |
- |
|
3 |
REAR ENGINE UNDER COVER RH |
51443C |
- |
- |
- |
![]() |
N*m (kgf*cm, ft.*lbf): Specified torque |
- |
- |
PROCEDURE
1. INSTALL CRANKSHAFT POSITION SENSOR

(1) Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.
NOTICE:
If reusing the crankshaft position sensor, check the O-ring.
(2) Install the crankshaft position sensor to the cylinder block sub-assembly with the bolt.
Torque:
10 N·m {102 kgf·cm, 7 ft·lbf}
NOTICE:
- Make sure that the O-ring is not cracked or moved out of place when installing crankshaft position sensor.
- If the crankshaft position sensor has been struck or dropped, replace it.
(3) Connect the crankshaft position sensor connector.
2. INSPECT FOR ENGINE OIL LEAK
Click here ![]()
3. INSTALL REAR ENGINE UNDER COVER RH










