Heated Steering Wheel Controller
Removal
REMOVAL
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the multiplex network steering ECU removal/installation are shown below.
CAUTION:
Be sure to read Precaution thoroughly before servicing.

Click here ![]()
NOTICE:
- Do not remove/install the spiral cable with sensor sub-assembly with the auxiliary battery connected and the ignition switch ON (IG).
- Do not rotate the spiral cable with sensor sub-assembly without the steering wheel assembly installed, with the auxiliary battery connected and the ignition switch ON.
- Ensure that the steering wheel assembly is installed and aligned straight when inspecting the steering sensor.
- After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal.
Click here

HINT:
When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when Toyota Prius vehicle is drivenEffect/Inoperative Function when Necessary Procedure not Performed | Necessary Procedure | Link |
|---|---|---|
Front Camera System |
Drive the Toyota Prius vehicle straight ahead at 35 km/h or more for 5 seconds or more. |
Effect/Inoperative Function when Necessary Procedure not Performed | Necessary Procedure | Link |
|---|---|---|
| *1: w/o Power Back Door System *2: w/ Power Back Door System |
||
Power Door Lock Control System*1
|
Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. |
|
Power Back Door System*2 |
Reset back door close position |
|
Air Conditioning System |
for HEV Model:
|
- |

Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
1 |
LOWER STEERING WHEEL BOSS COVER |
45184 |
- |
- |
- |
2 |
MULTIPLEX NETWORK STEERING ECU |
864A1A |
- |
- |
- |
PROCEDURE
1. REMOVE LOWER STEERING WHEEL BOSS COVER
Click here ![]()
2. REMOVE MULTIPLEX NETWORK STEERING ECU

*A |
w/ Steering Touch Sensor |
*B |
w/ Steering Heater |
(1) w/ Steering Touch Sensor:
1. Disconnect the connector and disengage the clamp.
(2) w/ Steering Heater:
1. Disconnect the connector.
(3) Remove the 2 screws, and multiplex network steering ECU.
Installation
INSTALLATION
COMPONENTS (INSTALLATION)
Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
1 |
MULTIPLEX NETWORK STEERING ECU |
864A1A |
- |
- |
- |
2 |
LOWER STEERING WHEEL BOSS COVER |
45184 |
- |
- |
- |
![]() |
N*m (kgf*cm, ft.*lbf): Specified torque |
- |
- |
PROCEDURE
1. INSTALL MULTIPLEX NETWORK STEERING ECU
Torque:
2,3 N·m {23 kgf·cm, 20 in·lbf}
2. INSTALL LOWER STEERING WHEEL BOSS COVER
Click here ![]()









