Digital Key Receiver (for Front Floor)
Removal
REMOVAL
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during ble indoor digital key receiver assembly removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/ReplacedReplaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
BLE indoor digital key receiver assembly |
Code registration |
|
NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.
Click here ![]()
HINT:
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
- Items for which learning is completed by driving the Toyota Prius vehicle
Effect/Inoperative Function When Necessary Procedures are not Performed
Necessary Procedures
Link
Front Camera System
Drive the Toyota Prius vehicle straight ahead at 35 km/h or more for 5 second or more.

- Items for which learning is completed by operating the vehicle normally
Effect/Inoperative Function When Necessary Procedures are not Performed
Necessary Procedures
Link
*1: w/o Power Back Door System *2: w/ Power Back Door System
Power Door Lock Control System*1
- Back door opener
Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch.

Power Back Door System*2
Reset back door close position

Air Conditioning System
for HEV Model: - After the ignition switch is turned to ON, the servo motor standard position is recognized.
- After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized.
-

Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
1 |
REAR CONSOLE BOX ASSEMBLY |
58910C |
- |
- |
|
2 |
BLE INDOOR DIGITAL KEY RECEIVER ASSEMBLY |
890G0 |
- |
- |
|
PROCEDURE
1. REMOVE REAR CONSOLE BOX ASSEMBLY
![]() |
Click here |
2. REMOVE BLE INDOOR DIGITAL KEY RECEIVER ASSEMBLY
![]() |
NOTICE: Be careful when removing the digital key receiver. If the digital key receiver is dropped, replace it with a new one. |

Installation
INSTALLATION
COMPONENTS (INSTALLATION)
Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
1 |
BLE INDOOR DIGITAL KEY RECEIVER ASSEMBLY |
890G0 |
- |
- |
|
2 |
REAR CONSOLE BOX ASSEMBLY |
58910C |
- |
- |
|
3 |
REGISTRATION DIGITAL KEY ECU |
- |
- |
- |
|
PROCEDURE
1. INSTALL BLE INDOOR DIGITAL KEY RECEIVER ASSEMBLY
![]() |
NOTICE: Be careful when installing the digital key receiver. If the digital key receiver is dropped, replace it with a new one. |
2. INSTALL REAR CONSOLE BOX ASSEMBLY
![]() |
Click here |
3. REGISTRATION DIGITAL KEY SYSTEM
Click here ![]()















