Power Seat Control Ecu
Removal
REMOVAL
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during position control ECU assembly removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/ReplacedReplaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| *: Even when not replacing the part, it is necessary to perform the specified necessary procedures after installation. | |||
Position control ECU assembly LH* |
Initialize position control ECU |
Front Power Seat Control System (w/ Memory) |
|
CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.
HINT:
When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
- Learning completes when Toyota Prius vehicle is driven
Effect/Inoperative Function when Necessary Procedure not Performed
Necessary Procedure
Link
Front Camera System
Drive the Toyota Prius vehicle straight ahead at 35 km/h or more for 5 seconds or more.

- Learning completes when vehicle is operated normally
Effect/Inoperative Function when Necessary Procedure not Performed
Necessary Procedure
Link
*1: w/o Power Back Door System *2: w/ Power Back Door System
Power Door Lock Control System*1
- Back door opener
Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch.

Power Back Door System*2
Reset back door close position

Air Conditioning System
for HEV Model: - After the ignition switch is turned to ON, the servo motor standard position is recognized.
- After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized.
-

Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
1 |
PRECAUTION |
- |
- |
- |
|
2 |
FRONT SEAT ASSEMBLY |
- |
- |
- |
- |
3 |
POSITION CONTROL ECU ASSEMBLY |
89710D |
- |
- |
- |
PROCEDURE
1. PRECAUTION
![]() |
NOTICE: After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal. Click here |
2. REMOVE FRONT SEAT ASSEMBLY
Click here ![]()
3. REMOVE POSITION CONTROL ECU ASSEMBLY

![]() |
Screw |
![]() |
Connector |
Installation
INSTALLATION
CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.
COMPONENTS (INSTALLATION) 
Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
1 |
POSITION CONTROL ECU ASSEMBLY |
89710D |
- |
- |
- |
2 |
FRONT SEAT ASSEMBLY |
- |
- |
- |
- |
PROCEDURE
1. INSTALL POSITION CONTROL ECU ASSEMBLY
2. INSTALL FRONT SEAT ASSEMBLY
Click here ![]()










