Horn
Removal
REMOVAL
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during low pitched horn assembly removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/ReplacedReplaced Part or Performed Procedure | Necessary Procedures | Effect/Inoperative Function When Necessary Procedures are not Performed | Link |
|---|---|---|---|
| *: Even when not replacing the part, it is necessary to perform the specified necessary procedures after installation. | |||
|
Front television camera view adjustment |
Panoramic View Monitor System |
|
Advanced Park |
|||
Replacement or removal and installation of 2 or more parts:
|
Television camera view adjustment |
Panoramic View Monitor System |
|

Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
1 |
FRONT BUMPER ASSEMBLY |
- |
- |
- |
- |
2 |
LOW PITCHED HORN ASSEMBLY |
86520 |
- |
- |
- |
PROCEDURE
1. REMOVE FRONT BUMPER ASSEMBLY
Click here ![]()
2. REMOVE LOW PITCHED HORN ASSEMBLY

Inspection
INSPECTION
PROCEDURE
1. INSPECT LOW PITCHED HORN ASSEMBLY
(a) Apply auxiliary battery voltage and check the operation of the low pitched horn assembly according to the table below. OK:
If the result is not as specified, replace the low pitched horn assembly. |
|
Installation
INSTALLATION
COMPONENTS (INSTALLATION)
Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
1 |
LOW PITCHED HORN ASSEMBLY |
86520 |
- |
- |
- |
2 |
FRONT BUMPER ASSEMBLY |
- |
- |
- |
- |
![]() |
N*m (kgf*cm, ft.*lbf): Specified torque |
- |
- |
PROCEDURE
1. INSTALL LOW PITCHED HORN ASSEMBLY
Torque:
19,5 N·m {199 kgf·cm, 14 ft·lbf}
2. INSTALL FRONT BUMPER ASSEMBLY
Click here ![]()










