Combination Meter
Removal
REMOVAL
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during combination meter removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/ReplacedReplaced Part or Performed Procedure | Necessary Procedures | Effect/Inoperative Function When Necessary Procedures are not Performed | Link |
|---|---|---|---|
Combination meter assembly |
Update ECU security key |
Toyota Prius Vehicle Control History (RoB) are stored |
NOTICE:
When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another Toyota Prius vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
COMPONENTS (REMOVAL)
Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
1 |
INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY |
55410C |
- |
- |
|
2 |
CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY |
55420A |
- |
- |
|
3 |
COMBINATION METER SUB-ASSEMBLY |
- |
- |
- |
- |
4 |
NO. 1 INSTRUMENT CLUSTER FINISH PANEL |
55411G |
- |
- |
- |
*1 |
COMBINATION METER ASSEMBLY |
- |
- |
PROCEDURE
1. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
![]() |
Click here |
2. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
![]() |
Click here |
3. REMOVE COMBINATION METER SUB-ASSEMBLY

![]() |
Remove in this Direction |
- |
- |
4. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL

![]() |
Remove in this Direction |
- |
- |
Installation
INSTALLATION
NOTICE:
After replacing the combination meter assembly, make sure to perform update ECU security key.
COMPONENTS (INSTALLATION)
Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
1 |
NO. 1 INSTRUMENT CLUSTER FINISH PANEL |
55411G |
- |
- |
- |
2 |
COMBINATION METER SUB-ASSEMBLY |
- |
- |
- |
|
3 |
CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY |
55420A |
- |
- |
- |
4 |
INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY |
55410C |
- |
- |
- |
5 |
UPDATE ECU SECURITY KEY |
- |
- |
- |
|
*1 |
COMBINATION METER ASSEMBLY |
- |
- |
PROCEDURE
1. INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL
2. INSTALL COMBINATION METER SUB-ASSEMBLY

![]() |
Install in this Direction |
- |
- |
(1) Connect each connector and engage the clamp.
(2) Engage the 2 guides and 2 clips as shown in the illustration.
(3) Install the combination meter sub-assembly with the 4 screws in the order shown in the illustration.
3. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
4. INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
5. UPDATE ECU SECURITY KEY
Click here ![]()















