Front Lower Suspension Arm (for 2zr-fxe Rh Side)
Removal
REMOVAL
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front lower No. 1 suspension arm sub-assembly RH removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/ReplacedReplaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| *: Even when not replacing the part, it is necessary to perform the specified necessary procedures after installation. *1: Also necessary after performing a tire rotation. *2: It is not necessary to perform this procedure if the tire pressure warning valve and transmitters are installed to the same location. *3: The Toyota Prius vehicle height changes because of tire replacement. *4: If matchmarks were not placed when removing parts related to steering operation, perform end position initial setting. |
|||
Front wheel alignment adjustment |
Perform "Calibration" |
|
|
Suspension parts |
Rear television camera assembly optical axis (Back camera position setting) |
Parking Assist Monitor System |
|
Parking assist ECU initialization |
Panoramic View Monitor System |
||
Advanced Park |
|||
Tires |
|
Tire Pressure Warning System |
Refer to Procedures Necessary When Replacing Parts (for Tire Pressure Warning System) |
Rear television camera assembly optical axis (Back camera position setting) |
Parking Assist Monitor System |
||
Parking assist ECU initialization*3 |
Panoramic View Monitor System |
||
Advanced Park |
|||
|
End position initial setting |
- |
|
Front bumper assembly* |
Front television camera view adjustment |
Panoramic View Monitor System |
|
Advanced Park |
|||

Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
1 |
FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY |
51201 |
- |
- |
- |
2 |
FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY RH |
48068 |
- |
- |
|
PROCEDURE
1. REMOVE FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY
Click here
![]()
2. REMOVE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY RH

(1) Remove the 2 bolts, nut and front lower No. 1 suspension arm sub-assembly RH from the front suspension crossmember sub-assembly.
NOTICE:
Because the nut has its own stopper, do not turn the nut. Loosen the bolt with the nut secured.
Installation
INSTALLATION
COMPONENTS (INSTALLATION)
Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
1 |
FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY RH |
48068 |
- |
- |
|
2 |
FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY |
51201 |
- |
- |
- |
PROCEDURE
1. TEMPORARILY INSTALL FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY RH

(1) Temporarily install the front lower No. 1 suspension arm sub-assembly RH to the front suspension crossmember sub-assembly with the 2 bolts and nut.
NOTICE:
Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.
2. INSTALL FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY
Click here
![]()


















