Knock Sensor
Removal
REMOVAL
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during knock control sensor removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/ReplacedReplaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
|
Inspection after repair |
|

Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
1 |
INTAKE MANIFOLD |
17111 |
- |
- |
- |
2 |
KNOCK CONTROL SENSOR |
89615 |
- |
- |
|
PROCEDURE
1. REMOVE INTAKE MANIFOLD
Click here ![]()
2. REMOVE KNOCK CONTROL SENSOR
![]() |
NOTICE: If the knock control sensor has been struck or dropped, replace it. |

Inspection
INSPECTION
PROCEDURE
1. INSPECT KNOCK CONTROL SENSOR
(a) Measure the resistance according to the value(s) in the table below. Standard Resistance:
If the result is not as specified, replace the knock control sensor. |
|
Installation
INSTALLATION
COMPONENTS (INSTALLATION)
Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
1 |
KNOCK CONTROL SENSOR |
89615 |
- |
- |
|
2 |
INTAKE MANIFOLD |
17111 |
- |
- |
- |
3 |
PERFORM INITIALIZATION |
- |
- |
- |
|
![]() |
N*m (kgf*cm, ft.*lbf): Specified torque |
- |
- |
PROCEDURE
1. INSTALL KNOCK CONTROL SENSOR

*a |
Top |
*b |
10° |
(1) Install the knock control sensor to the cylinder block sub-assembly with the bolt as shown in the illustration.
Torque:
21 N·m {214 kgf·cm, 15 ft·lbf}
NOTICE:
- If the knock control sensor has been struck or dropped, replace it.
- Make sure that the knock control sensor is in the correct position.
(2) Connect the knock control sensor connector.
2. INSTALL INTAKE MANIFOLD
Click here ![]()
3. PERFORM INITIALIZATION
(a) Perform "Inspection After Repair" after replacing the knock control sensor.
Click here ![]()












