Door Outside Handle (for Rear Side)
- Removal
- Inspection
- Installation
Removal
REMOVAL
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during rear door outside handle assembly removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/ReplacedReplaced Part or Performed Procedure | Necessary Procedures | Effect/Inoperative Function When Necessary Procedures are not Performed | Link |
|---|---|---|---|
| *: Even when not replacing the part, it is necessary to perform the specified necessary procedures after installation. | |||
|
Initialize power window control system |
|
|
HINT:
- When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
- Learning completes when Toyota Prius vehicle is driven
Effect/Inoperative Function When Necessary Procedures are not Performed
Necessary Procedures
Link
Front Camera System
Drive the Toyota Prius vehicle straight ahead at 35 km/h or more for 5 seconds or more.

- Learning completes when vehicle is operated normally
Effect/Inoperative Function When Necessary Procedures are not Performed
Necessary Procedures
Link
*1: w/o Power Back Door System *2: w/ Power Back Door System
Power Door Lock Control System*1
- Back door opener
Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch.

Power Back Door System*2
Reset back door close position

Air Conditioning System
for HEV Model: - After the ignition switch is turned to ON, the servo motor standard position is recognized.
- After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized.
-
- Learning completes when Toyota Prius vehicle is driven
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.

Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
1 |
REAR DOOR BELT MOULDING ASSEMBLY |
75740 |
- |
- |
- |
2 |
REAR DOOR OUTSIDE HANDLE ASSEMBLY |
69240 |
- |
- |
- |
PROCEDURE
1. REMOVE REAR DOOR BELT MOULDING ASSEMBLY
Click here ![]()
2. REMOVE REAR DOOR OUTSIDE HANDLE ASSEMBLY
Click here ![]()
Inspection
INSPECTION
PROCEDURE
1. INSPECT REAR DOOR OUTSIDE HANDLE ASSEMBLY LH
(a) Check the operation of the rear door outside handle assembly LH.
(1) Measure the resistance according to the value(s) in the table below. Standard Resistance:
If the result is not as specified, replace the rear door outside handle assembly LH. |
|
2. INSPECT REAR DOOR OUTSIDE HANDLE ASSEMBLY RH
(a) Check the operation of the rear door outside handle assembly RH.
(1) Measure the resistance according to the value(s) in the table below. Standard Resistance:
If the result is not as specified, replace the rear door outside handle assembly RH. |
|
Installation
INSTALLATION
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.

Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
1 |
REAR DOOR OUTSIDE HANDLE ASSEMBLY |
69240 |
- |
- |
- |
2 |
REAR DOOR BELT MOULDING ASSEMBLY |
75740 |
- |
- |
- |
![]() |
N*m (kgf*cm, ft.*lbf): Specified torque |
- |
- |
PROCEDURE
1. INSTALL REAR DOOR OUTSIDE HANDLE ASSEMBLY
Click here ![]()
2. INSTALL REAR DOOR BELT MOULDING ASSEMBLY
Click here ![]()









