Hybrid Transaxle Side Gear Oil Seal
Components
COMPONENTS
ILLUSTRATION

*1 |
DIFFERENTIAL SIDE GEAR SHAFT TYPE T OIL SEAL LH |
*2 |
DIFFERENTIAL SIDE GEAR SHAFT TYPE T OIL SEAL RH |
● |
Non-reusable part |
![]() |
MP grease |
Replacement
REPLACEMENT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during differential side gear shaft type T oil seal LH or differential side gear shaft type T oil seal RH removal/installation are shown below.
Necessary Procedures after parts removed/installed/replacedReplaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| *1: Also necessary after performing a tire rotation. *2: It is not necessary to perform this procedure if the tire pressure warning valve and transmitters are installed to the same location. |
|||
Suspension parts |
Rear television camera assembly optical axis (Back camera position setting) |
Parking Assist Monitor System |
|
Parking assist ECU initialization |
Panoramic View Monitor System |
||
Advanced Park |
|||
Tires |
|
Tire Pressure Warning System |
Refer to Procedures Necessary When Replacing Parts (for Tire Pressure Warning System) table below |
Rear television camera assembly optical axis (Back camera position setting) |
Parking Assist Monitor System |
||
Parking assist ECU initialization |
Panoramic View Monitor System |
||
Advanced Park |
|||
Rear wheel alignment adjustment |
Perform "Calibration" |
|
|
PROCEDURE
1. REMOVE DIFFERENTIAL SIDE GEAR SHAFT SUB-ASSEMBLY LH
Click here ![]()
2. REMOVE DIFFERENTIAL SIDE GEAR SHAFT SUB-ASSEMBLY RH
Click here ![]()
3. REMOVE DIFFERENTIAL SIDE GEAR SHAFT TYPE T OIL SEAL LH
(a) Using SST, remove the differential side gear shaft type T oil seal LH from the rear traction motor with transaxle assembly. SST: 09308-00010 NOTICE: Do not damage the rear traction motor with transaxle assembly. |
![]() |
4. REMOVE DIFFERENTIAL SIDE GEAR SHAFT TYPE T OIL SEAL RH
(a) Using SST, remove the differential side gear shaft type T oil seal RH from the rear traction motor with transaxle assembly. SST: 09308-00010 NOTICE: Do not damage the rear traction motor with transaxle assembly. |
![]() |
5. INSTALL DIFFERENTIAL SIDE GEAR SHAFT TYPE T OIL SEAL LH
(a) Using SST and a hammer, install a new differential side gear shaft type T oil seal LH to the rear traction motor with transaxle assembly. SST: 09223-00010 Standard Depth: -0.5 to 0.5 mm (-0.0197 to 0.0197 in.) NOTICE:
|
|
(b) Coat the lip of the differential side gear shaft type T oil seal LH with a small amount of MP grease.
6. INSTALL DIFFERENTIAL SIDE GEAR SHAFT TYPE T OIL SEAL RH
(a) Using SST and a hammer, install a new differential side gear shaft type T oil seal RH to the rear traction motor with transaxle assembly. SST: 09223-00010 Standard Depth: -0.5 to 0.5 mm (-0.0197 to 0.0197 in.) NOTICE:
|
|
(b) Coat the lip of the differential side gear shaft type T oil seal RH with a small amount of MP grease.
7. INSTALL DIFFERENTIAL SIDE GEAR SHAFT SUB-ASSEMBLY LH
Click here ![]()
8. INSTALL DIFFERENTIAL SIDE GEAR SHAFT SUB-ASSEMBLY RH
Click here ![]()












