5Th main gear assembly
In this manual: 5Th main gear assembly
7steps
~42min
2/5difficulty
Done 0 of 7
Removal and Installation
REMOVAL
- Move the shift selector to the 3rd gear position.
- Disconnect the shifter cable and the selector cable from shifter lever A and selector lever. Refer to TM, "Removal and Installation".
CAUTION: Do not move shifter lever A and selector lever to disconnect each cable.
- Drain gear oil. Refer to TM, "Draining".
- Remove fender protector (LH). Refer to EXT, "Removal and Installation".
- Remove the harness clamp (A) from rear housing (1).

- Remove rear housing and O-ring.
CAUTION: Remove in direction of input shaft (
) as shown. Rear housing oil channel is inserted to input shaft center hole. - Remove 5th main gear assembly. Refer to step 5 through 8 of "Disassembly of TRANSAXLE ASSEMBLY". Refer to TM, "Disassembly".

INSTALLATION
Installation is in the reverse order of removal.
- Shift into 3rd with shifter lever to install the 5th main gear assembly, referring to Step 36 to 39 of "Assembly of TRANSAXLE ASSEMBLY" Refer to TM, "Assembly".
- Install O-ring and the rear housing to the transaxle case and tighten the bolts to the specified torque. Refer to TM, "Exploded View".
CAUTION:
- Do not reuse O-ring.
- Do not pinch O-ring when installing rear housing.
- Refill gear oil. Refer to TM, "Refilling".
Inspection
INSPECTION AFTER INSTALLATION
- Check the operation of the control linkage. Refer to TM, "Inspection".
- Check the oil level and for oil leakage. Refer to TM, "Inspection".
Was this page helpful?