High-pressure flexible hose
In this manual: High-pressure flexible hose
6steps
~36min
2/5difficulty
Done 0 of 6
Removal and Installation
CAUTION: Perform oil return operation before each refrigeration system disassembly. However, if a large amount of refrigerant or oil is detected, do not perform oil return operation. Refer to HA "Perform Oil Return Operation".
REMOVAL
- Use refrigerant collecting equipment (for HFC-134a) to discharge the refrigerant. Refer to HA "Refrigerant Cycle".
- Remove air duct (inlet). Refer to EM "Exploded View".
- Remove the engine under cover. Refer to EXT "Removal and Installation".
- Remove high-pressure flexible hose bolt and disconnect high-pressure flexible hose from the condenser.
CAUTION: Cap or wrap the joint of the A/C piping and condenser with suitable material such as vinyl tape to avoid the entry of air.
- Remove high-pressure flexible hose bolt and disconnect high-pressure flexible hose from the compressor.
CAUTION: Cap or wrap the joint of the A/C piping and compressor with suitable material such as vinyl tape to avoid the entry of air.
- Remove the high-pressure flexible hose.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
- Do not reuse O-rings.
- Apply A/C oil to the O-ring of the high-pressure flexible hose for installation.
- After charging the A/C refrigerant, check for leaks. Refer to HA "Leak Test".
Was this page helpful?