P0744 Torque converter
DTC Logic
DTC DETECTION LOGIC
| DTC | Trouble diagnosis name | DTC detection condition | Possible causes |
| P0744 | Torque converter clutch circuit intermittent | The torque converter slip speed is at or above a set value (40 rpm + (Vehicle speed / 2) continuously for 30 seconds or more under the following diagnosis conditions: - Diagnosis conditions - Selector lever: "D" position - Accelerator pedal position: 1.0/8 or more - Vehicle speed: 10 km/h or more - Engine speed: 450 rpm or more - CVT fluid temperature: 20C (68F) ≤ CVT fluid temperature ≤ 180C (356F) - Lockup command is being given (except for slip lockup). - LU PRS: More than 0.2 MPa - TCM power supply voltage: More than 11 V |
- Torque converter clutch solenoid valve - Control valve assembly - Torque converter |
DTC CONFIRMATION PROCEDURE
CAUTION: Be careful of the driving speed.
1.PREPARATION BEFORE OPERATION 1
If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.
>> GO TO 2.
2.PREPARATION BEFORE OPERATION 2
With CONSULT
- Start the engine.
- Select "Data Monitor" in "TRANSMISSION".
- Select "FLUID TEMP".
- Confirm that the CVT fluid temperature is in the range below.
FLUID TEMP : 20C (68F) or more
With GST
- Start the engine.
- Set the CVT fluid to 20C (68F) or more.
NOTE: When the ambient temperature is 20C (68F), the CVT fluid usually increases to 50 to 80C (122 to 176F) with driving in an urban area for approximately 10 minutes.
Is the CVT fluid 20C (68F) or more?
YES >> GO TO 3.
NO >> 1. Warm the transaxle. 2. GO TO 3.
3.CHECK DTC DETECTION
- Drive the vehicle.
- Maintain the following conditions for 40 seconds or more.
Selector lever : "D" position
Accelerator pedal position : 1.0/8 or more
Vehicle speed : 40 km/h or more
3. Stop the vehicle.
4. Check the first trip DTC.
Is "P0744" detected?
YES >> Go to TM "Diagnosis Procedure".
NO >> INSPECTION END
Diagnosis Procedure
1.CHECK LINE PRESSURE
Perform line pressure test. Refer to TM "Work Procedure".
Is the inspection result normal?
YES >> GO TO 2.
NO >> Repair or replace the malfunction items.
2.CHECK TORQUE CONVERTER CLUTCH SOLENOID VALVE
- Turn ignition switch OFF.
- Disconnect CVT unit connector.
- Check torque converter clutch solenoid valve. Refer to TM "Component Inspection (Torque Converter Clutch Solenoid Valve)".
Is the inspection result normal?
YES >> GO TO 3.
NO >> Repair or replace the malfunction items.
3.CHECK INTERMITTENT INCIDENT
Refer to GI "Intermittent Incident".
Is the inspection result normal?
YES >> Replace the transaxle assembly. Refer to TM, "Removal and Installation".
NO >> Repair or replace the malfunction items.
Component Inspection (Torque Converter Clutch Solenoid Valve)
1.CHECK TORQUE CONVERTER CLUTCH SOLENOID VALVE
Check resistance between CVT unit connector terminal and ground. 
Is the inspection result normal?
YES >> INSPECTION END
NO >> There is a malfunction of torque converter clutch solenoid valve. Replace transaxle assembly.
Refer to TM "Removal and Installation".