NATS antenna AMP
In this manual: NATS antenna AMP
~1min read
Removal and Installation
NOTE:
- If NATS antenna amp. is not installed correctly, NVIS (NATS) system will not operate properly and "SELFDIAG RESULTS" on CONSULT screen will show "LOCK MODE" or "CHAIN OF IMMU-KEY".
- Initialization is not necessary when only the NATS antenna amp. is replaced with a new one.
REMOVAL
1. Disconnect the battery negative terminal. Refer to PG "Removal and Installation".
2. Remove the instrument lower panel LH. Refer to IP "Removal and Installation".
3. Remove the NATS antenna amp bolt (A).
4. Disconnect the harness connector (1) from the NATS antenna amp. (2) and remove.

INSTALLATION
Installation is in the reverse order of removal.
Was this page helpful?