P0717 Input speed sensor A
DTC Logic
DTC DETECTION LOGIC
| DTC | Trouble diagnosis name | DTC detection condition | Possible causes |
| P0717 | Input/Turbine Speed Sensor "A" Circuit No Signal | Under the following diagnosis conditions, the input speed sensor value is less than 600 rpm continuously for 5 seconds or more. - Diagnosis condition - Engine speed: More than 1,500 rpm - Position: Other than P or N - Idle switch: OFF - Vehicle speed: More than 40 km/h - TCM power supply voltage: 10 V <TCM power supply voltage <16 V |
|
DTC CONFIRMATION PROCEDURE
CAUTION: Be careful of the driving speed.
1.PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.
>> GO TO 2.
2.CHECK DTC DETECTION
- Start the engine.
- Drive the vehicle.
- Maintain the following conditions for 5 seconds or more.
- Stop the vehicle.
- Check the first trip DTC.
Engine speed : More than 1,500 rpm
Accelerator pedal position : 0.5/8.0 or more
Selector lever : D position
Vehicle speed : More than 40 km/h
Is "P0717" detected?
YES >> Go to TM, "Diagnosis Procedure".
NO >> INSPECTION END
Diagnosis Procedure
1.CHECK INPUT SPEED SENSOR POWER CIRCUIT
- Turn ignition switch OFF.
- Disconnect the transaxle assembly connector.
- Turn ignition switch ON.
- Check the voltage between the A/T unit harness connector and ground.

Is the check result normal?
YES >> GO TO 2.
NO >> Check the TCM power supply. Refer to TM, "Diagnosis Procedure".
2.CHECK INPUT SPEED SENSOR GROUND CIRCUIT
- Turn ignition switch OFF.
- Check the continuity between the A/T unit harness connector and ground.

Is the check result normal?
YES >> GO TO 3.
NO >> Check or repair the malfunction items.
3.CHECK INPUT SPEED SENSOR SIGNAL CIRCUIT
- Disconnect the TCM connector.
- Check the continuity between the TCM harness connector and the A/T unit harness connector.

Is the check result normal?
YES >> GO TO 4.
NO >> Check or repair the malfunction items.
4.CHECK INPUT SPEED SENSOR TCM CIRCUIT (CHECK 3)
Check the continuity between TCM harness connector and ground. 
Is the check result normal?
YES >> GO TO 5.
NO >> Check or repair the malfunction items.
5.CHECK TCM INPUT SIGNALS
- Connect all of the disconnected connectors.
- Lift the vehicle.
- Start the engine.
- Check the frequency of the input speed sensor.

Is the check result normal?
YES >> Perform a simulation test to judge the cause of the malfunction. Refer to GI, "Intermittent Incident".
NO >> Replace the transaxle assembly. Refer to TM, "Removal and Installation".