C1610 Engine status signal
Description
EPS control unit receives the engine status signal from ECM via CAN communication line.
DTC Logic
DTC DETECTION LOGIC 
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
>> GO TO 2.
2.DTC REPRODUCTION PROCEDURE
With CONSULT
- Turn the ignition switch OFF to ON.
- Perform "EPS" self-diagnosis.
Is DTC "C1610" detected?
YES >> Proceed to diagnosis procedure. Refer to STC "Diagnosis Procedure".
NO >> Inspection End.
Diagnosis Procedure
1.PERFORM ECM SELF-DIAGNOSIS
With CONSULT
- Turn the ignition switch OFF to ON.
- Perform "ENGINE" self-diagnosis. Refer to EC"CONSULT Function".
Is any DTC detected?
YES >> Check the DTC. Refer to EC "DTC Index".
NO >> GO TO 2.
2.PERFORM SELF-DIAGNOSIS
With CONSULT
Perform "EPS" self-diagnosis.
Is DTC "C1610" detected?
YES >> Replace EPS control unit. Refer to STC "Removal and Installation".
NO >> Check EPS control unit pin terminals for damage or loose connection with harness connector. If any item are damaged, repair or replace malfunctioning components.