P0965 Pressure control solenoid B
DTC Logic
DTC DETECTION LOGIC
| DTC | Trouble diagnosis name | DTC detection condition | Possible causes |
| P0965 | Pressure control solenoid B control circuit range performance | The detection conditions continuously for 5 seconds or more under the following diagnosis conditions: - Diagnosis conditions - Selector lever: Other than "P" and "N" positions - Auxiliary gearbox shifting is not in progress. - Engine speed: More than 500 rpm - Detection condition A - Actual primary pulley ratio: 2.0 - 2.4 - Target primary pulley ratio: Less than 1.2 - Detection condition B - Actual primary pulley ratio: 0.35 - 0.75 - Target primary pulley ratio: More than 1.55 |
Primary pressure solenoid valve |
DTC CONFIRMATION PROCEDURE
CAUTION:
- Be sure to perform "TM "Diagnosis Procedure"" and then perform "DTC CONFIRMATION PROCEDURE".
- Never perform "DTC CONFIRMATION PROCEDURE" before the repairs. Doing so may result in a secondary malfunction.
- Be careful of the driving speed.
1.PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.
>> GO TO 2.
2.CHECK DTC DETECTION
- Start the engine.
- Drive the vehicle.
- Maintain the following conditions for 20 seconds or more.
- Stop the vehicle.
- Check the first trip DTC
Vehicle speed : 20 km/h or more
Is "P0965"detected?
YES >> Go to TM "Diagnosis Procedure".
NO >> INSPECTION END
Diagnosis Procedure
1.CHECK INTERMITTENT INCIDENT
Refer to GI "Intermittent Incident".
Is the inspection result normal?
YES >> Replace transaxle assembly. Refer to TM "Removal and Installation".
NO >> Repair or replace malfunctioning parts.