P1715 Input speed sensor
Description
ECM receives input speed sensor signal from TCM via the CAN communication line. ECM uses this signal for engine control.
DTC Logic
DTC DETECTION LOGIC
NOTE:
- If DTC P1715 is displayed with DTC UXXXX, first perform the trouble diagnosis for DTC UXXXX.
- If DTC P1715 is displayed with DTC P0335, first perform the trouble diagnosis for DTC P0335. Refer to EC, "DTC Logic".
- If DTC P1715 is displayed with DTC P0340, first perform the trouble diagnosis for DTC P0340. Refer to EC, "DTC Logic".
- If DTC P1715 is displayed with DTC P0605, first perform the trouble diagnosis for DTC P0605. Refer to EC, "DTC Logic".
| DTC No. | Trouble diagnosis | DTC detecting condition | Possible cause |
| P1715 | Input speed sensor (TCM output) | Input speed sensor signal is different from the theoretical value calculated by ECM from output speed sensor signal and engine rpm signal. |
|
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next test.
- Turn ignition switch OFF and wait at least 10 seconds.
- Turn ignition switch ON.
- Turn ignition switch OFF and wait at least 10 seconds.
>> GO TO 2.
2.PERFORM DTC CONFIRMATION PROCEDURE
- Start engine and drive the vehicle at more than 50 km/h for at least 5 seconds.
CAUTION: Always drive vehicle at a safe speed.
- Check 1st trip DTC.
Is 1st trip DTC detected?
YES >> Go to EC, "Diagnosis Procedure".
NO >> INSPECTION END
Diagnosis Procedure
1.CHECK DTC WITH TCM
Check DTC with TCM. Refer to TM, "DTC Index" (A/T models) or TM, "DTC Index" (CVT models).
Is the inspection result normal?
YES >> GO TO 2.
NO >> Perform trouble shooting relevant to DTC indicated.
2.REPLACE TCM
Replace TCM. Refer to TM, "Removal and Installation" (A/T models) or TM, "Removal and Installation" (CVT models).
>> INSPECTION END