Oil filter
In this manual: Oil filter
9steps
~54min
2/5difficulty
Done 0 of 9
Removal and Installation
REMOVAL
- Remove engine under cover.
- Drain engine oil.
- Remove oil filter using Tool (A).
: Front
Tool number : KV10115801 (J38956)

WARNING:
Be careful not to get burned; engine and engine oil may be hot.
CAUTION:
- When removing, prepare a shop cloth to absorb engine oil leaks and spills.
- Do not spill engine oil on drive belt.
- Completely wipe off any engine oil that spills on engine and vehicle.
- Oil filter is provided with relief valve. Use Genuine NISSAN oil filter or equivalent.
INSTALLATIN
- Remove foreign materials adhering to the oil filter installation surface.
- Apply new engine oil to the oil seal contact surface of new oil filter.

3. Screw oil filter manually until it touches the installation surface, then tighten it by 2/3 turn (A), or tighten to specification.
Oil filter : 17.7 N*m (1.8 kgm, 13 ftlb)

4. Refill engine with new engine oil.
5. Install engine under cover.
Inspection
INSPECTION AFTER INSTALLATION
- Check the engine oil level.
- Start the engine and ensure there are no engine oil leaks.
- Stop the engine and wait for 10 minutes.
- Check the engine oil level and adjust as necessary.
Was this page helpful?