Accelerator control system
In this manual: Accelerator control system
3steps
~18min
2/5difficulty
Done 0 of 3
Exploded View

1. Accelerator pedal assembly 2. Brake pedal bracket A. Locating hook B. Locating pin
Removal and Installation
CAUTION:
- Do not disassemble accelerator pedal assembly. Do not remove accelerator pedal position sensor from accelerator pedal assembly.
- Avoid impact from dropping etc. during handling.
- Be careful to keep accelerator pedal assembly away from water.
REMOVAL
- Disconnect the battery negative terminal. Refer to PG, "Removal and Installation".
- Disconnect the harness connector from the accelerator pedal position sensor.
- Remove the accelerator pedal assembly bolts and the accelerator pedal assembly.
INSTALLATION
Installation is in the reverse order of removal.
- When installing the accelerator pedal assembly, align the locating hook and locating pin holes on the brake pedal bracket.
CAUTION: Do not squeeze the locating hook in the break pedal bracket when inserting the locating pin into the hole on the brake pedal bracket side.
- After installation, perform inspection of the accelerator pedal assembly.
- Check that the accelerator pedal moves smoothly within the specified range.
Accelerator pedal travel (A) : Refer to ACC, "Accelerator Control"
- Depress and release the accelerator pedal to check that it returns quickly and smoothly to the original released position.
- Perform an electrical inspection of accelerator pedal position sensor.
Refer to EC, "Component Inspection".
CAUTION:
- Whenever the harness connector of accelerator pedal position sensor is disconnected, perform "ACCELERATOR PEDAL RELEASED POSITION LEARNING". Refer to EC, "Work Procedure".
- The accelerator pedal should return smoothly without catching to the fully raised position.

SERVICE DATA AND SPECIFICATIONS (SDS)
Accelerator Control
PEDAL TRAVEL

Was this page helpful?