P1720 VSS
Description
ECM receives two vehicle speed signals via the CAN communication line. One is sent from "ABS actuator and electric unit (control unit)" via combination meter, and the other is from TCM (Transmission control module).
ECM uses these signals for engine control.
DTC Logic
DTC DETECTION LOGIC
NOTE:
- If DTC P1720 is displayed with DTC UXXXX, first perform the trouble diagnosis for DTC UXXXX.
- If DTC P1720 is displayed with DTC P0605, first perform the trouble diagnosis for DTC P0605. Refer to EC, "DTC Logic".
- If DTC P1720 is displayed with DTC P0607, first perform the trouble diagnosis for DTC P0607. Refer to EC, "DTC Logic".
| DTC No. | Trouble diagnosis | DTC detecting condition | Possible cause |
| P1720 | Vehicle speed sensor (TCM output) | The difference between two vehicle speed signals is out of the specified range. |
|
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next test.
- Turn ignition switch OFF and wait at least 10 seconds.
- Turn ignition switch ON.
- Turn ignition switch OFF and wait at least 10 seconds.
>> GO TO 2.
2.PERFORM DTC CONFIRMATION PROCEDURE
- Start engine.
- Drive vehicle at a speed of 20 km/h or more for at least 5 seconds without depressing the brake pedal.
- Check 1st trip DTC.
Is 1st trip DTC detected?
YES >> Go to EC, "Diagnosis Procedure".
NO >> INSPECTION END
Diagnosis Procedure
1.CHECK DTC WITH TCM
Check DTC with TCM. Refer to TM, "DTC Index" (A/T models) or TM, "DTC Index" (CVT models).
Is the inspection result normal?
YES >> GO TO 2.
NO >> Perform trouble shooting relevant to DTC indicated.
2.CHECK DTC WITH "ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)"
Check DTC with "ABS actuator and electric unit (control unit)". Refer to BRC, "DTC Index".
Is the inspection result normal?
YES >> GO TO 3.
NO >> Perform trouble shooting relevant to DTC indicated.
3.CHECK COMBINATION METER FUNCTION
Check combination meter function. Refer to MWI, "DTC Index" (TYPE A) or MWI, "DTC Index" (TYPE B).
>> INSPECTION END