BCM (Body control module)
In this manual: BCM (Body control module)
~1min read
Removal and Installation
CAUTION: Before replacing BCM, perform "READ CONFIGURATION" to save or print current vehicle specification.
Refer to BCS "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT (BCM) : Description".
REMOVAL
1. Disconnect the negative battery terminal. Refer to PG"Removal and Installation".
2. Remove instrument lower panel LH. Refer to IP "Removal and Installation".
3. Remove BCM screws (A) and pull out the BCM (B).
4. Disconnect the harness connectors from the BCM (B) and remove.

INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
- Be sure to perform "WRITE CONFIGURATION" when replacing BCM. Refer to BCS "CONFIGURATION (BCM) : Work Procedure".
- For Canada, be sure to perform the system initialization (NATS) when replacing BCM. Refer to BCS "CONFIGURATION (BCM) : Work Procedure".
- When replacing BCM, if new BCM does not come with keyfobs attached, all existing keyfobs must be re-registered.
Was this page helpful?