Transverse link
In this manual: Transverse link
3steps
~18min
2/5difficulty
Done 0 of 3
Exploded View

1. Front suspension member 2. Transverse link
Removal and Installation
REMOVAL
- Remove the wheel and tire assembly using power tool. Refer to WT "Adjustment".
- Remove transverse link from steering knuckle. Refer to FAX "Exploded View".
- Remove transverse link from suspension member.
INSPECTION AFTER REMOVAL
Visual Inspection
Check the following:
- Transverse link and bushing for deformation, cracks or damage. Replace it if necessary.
- Ball joint boot for cracks or other damage, and also for grease leakage. Replace it if necessary.
Ball Joint Inspection
Manually move ball stud to confirm it moves smoothly with no binding.
Swing Torque Inspection
NOTE: Before measurement, move ball stud at least ten times by hand to check for smooth movement.
- Hook Tool at the cutout on ball stud. Confirm Tool measurement value is within specifications when ball stud begins moving.
Tool number : - (J-44372)
Swing torque : Refer to FSU "Ball Joint".
Spring balance measurement : Refer to FSU "Ball Joint".

- If it is outside the specified range, replace transverse link assembly.
Axial End Play Inspection
- Move tip of ball stud in axial direction to check for looseness.
Axial end play : Refer to FSU "Ball Joint".
- If it is outside the specified range, replace transverse link assembly.
INSTALLATION
Installation is in the reverse order of removal.
- For tightening specifications, refer to FSU "Exploded View".
- Perform final tightening of bolts and at the front suspension member installation position (rubber bushing) under unladen conditions with tires on level ground. Check wheel alignment. Refer to FSU "Wheel Alignment".
Was this page helpful?