Clutch pedal
In this manual: Clutch pedal
8steps
~48min
2/5difficulty
Done 0 of 8
Exploded View

1. Clutch pedal 2. Pedal stopper rubber 3. Pedal pad 4. Clip 5. Clutch interlock switch
Removal and Installation
REMOVAL
- Remove the instrument lower panel LH. Refer to IP, "Removal and Installation".
- Disconnect master cylinder rod end from clutch pedal.
- Disconnect clutch interlock switch connector.
- Remove harness clip from clutch pedal.
- Remove clutch pedal nuts and remove clutch pedal from the vehicle.
- Remove pedal pad from clutch pedal.
- Remove clutch interlock switch and clip from clutch pedal.
- Remove pedal stopper rubber from clutch pedal, using a suitable tool.

INSTALLATION
Installation is in the reverse order of removal.
CAUTION: Press master cylinder rod end into clutch pedal until it stops.
Inspection and Adjustment
INSPECTION AFTER REMOVAL
- Check clutch pedal for bend, damage, or a cracked weld. If bend, damage, or a cracked weld is found, replace clutch pedal.
- Check pedal stopper rubber. If damage or deformation is found, replace pedal stopper rubber.
- Check pedal pad. If wear or damage is found, replace pedal pad.
INSPECTION AND ADJUSTMENT AFTER INSTALLATION
Inspect the clutch interlock switch position and adjust as necessary. Refer to CL, "Inspection and Adjustment".
Was this page helpful?